Connecting To The Lan Line; Network Configuration - Sanyo PLC-XR251 Owner's Manual
Sanyo projector user manual
Hide thumbs
Also See for PLC-XR251:
- Owner's manual (77 pages) ,
- Service manual (112 pages) ,
- Service manual (11 pages)
Table of Contents
Advertisement
Chapter 2 Setup Procedures
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.
Connecting to the LAN line
Connect the LAN cable to the LAN connection terminal of the projector.
Network configuration
Set the Wired LAN network through the projector menu. Detailed network settings will be
made with browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the
settings described in this chapter before performing steps in "3. Basic setting and opera-
tion."
Setting Procedure
1. Select "LAN mode select" in the Network menu, and press Point
2. Select similar LAN environment among LAN1, LAN2 and LAN3 with the Point
tons. Then the Menu will disappear, the "Please wait..." message will appear, and switch-
ing operation will start. Switching will take a while and the projector's LINK/ACT Lamp
will be on or blink, and after completing the operation, the "Please wait..." message will
disappear.
12
LAN Connection
Terminal
LAN Cable
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.
or SELECT button.
but-
- Quick Links:
- Features and Design
- Computer Input
Hide quick links:
Advertisement
Chapters
Table of Contents
