Table 10-10 Technical Data - 411 Profibus Module; Table 10-11 Profibus Ordering Information - Siemens MICROMASTER 411 Operating Instructions Manual
Siemens welding system - ac/dc welding inverter user manual
Hide thumbs
Also See for MICROMASTER 411:
- Operating instructions manual (28 pages) ,
- Getting started manual (20 pages) ,
- Operating instructions manual (74 pages)
Table of Contents
Advertisement
Issue 03/01
Quick Guide to setting up PROFIBUS
The bus cable between the master device and the drive must be connected
correctly. this includes the necessary termination resistors.
Bus Termination within the PROFIBUS module can be achieved using the
termination switch (SW1).
The bus cable must be screened and the screen must be connected to the
housing of the cable connector.
The PROFIBUS master must be configured correctly so that communications
can be realized with a DP slave using PPO type 1 or PPO type 3 (only PPO
type 1, if the PPO type cannot be configured via remote operator control).
Installation should be in conformance with EMC directives and regulations (this is
described in detail in the operating manuals for the drive and the PLC).
Table 10-10 Technical data – 411 PROFIBUS Module
Dimensions H x W x D
Degree of protection
Maximum bus speed
Table 10-11 PROFIBUS Ordering information
Designation
PROFIBUS module
MICROMASTER 411 & COMBIMASTER 411
6SE6400-5CA00-0BP0
Item
107,8 mm x 128 mm x 40,5 mm
IP66
12 MBaud
6SE6401-1PB00-0AA00
Operating Instructions
10 Engineering Information
Description
Order No.
151
- Quick Links:
- Faults and Alarms
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
