Table of Contents
Advertisement
[Step II. Wen setting "PORT" to "Tally"]
PORT:TALLY
DELAY: 0s000ms
↓◄►keys
PORT:TALLY
DELAY: 0s000ms
↓◄►keys
TALLY22
-
↓◄►keys
TALLY22
ON
PULSE:NONE
↓◄►keys
TALLY23
-
◄►keys
TALLY49
-
↓◄►keys
MEMO:
1:
↓ SET key: Applies settings.
[PRESET COMMAND 1]
NOW UPDATE...
↓
[COMMAND EDIT]
CMD
1
Note:
If you do not press the "SET" key, the control command is not changed. Make sure to press the "SET" key.
Tally output: only pins 22 to 24 and 47 to 49 can be used for control commands using open collector method.
The maximum supplied currency of internal power (pins1 and 26) is 300 mA. Do not use external power and
internal power at the same time.
The maximum load of pins 22 to 24 and 47 to 49 is DC +48 V and 1 A. (different from the maximum load of
other pins)
▲▼keys: Set the delay time in seconds (0 to 999).
▲▼keys: Set the delay time in milliseconds (0 to 999).
▲▼keys: Select the control of Tally output pin 22 (-, OFF, ON, or
TGL).
▲▼keys: Set the pulse of Tally output pin 22 (NONE, 100 to 9990).
Displayed only if you select "ON" or "OFF" on the previous screen
(setting for control).
▲▼keys: Select the control of Tally output pin 23 (-, OFF, ON, TGL).
◄►keys: Moves the cursor to the setting for next pin.
▲▼keys: Select the control of Tally output pin 49 (-, OFF, ON, TGL).
◄►keys: Move cursor to the setting for next channel.
▲▼keys Set the "MEMO" (20 to 7D of "9 ASCII codes" except for 2C).
◄►keys: Moves the cursor to the next character (Up to 14 characters).
The message is displayed for one second and then previous screen is
displayed automatically.
+5 V (4.5 V ~ 5.5 V)
300 mA
Pin 22
Pin 23
Pin 24
Pin 25
Inside of MSD-5404
When internal power is used.
[Figure 8.51] Examples of Tally output circuit
+5 V (4.5 V ~ 5.5 V)
Pins 1 and 26
300 mA
Pin 22
Pin 23
Pin 24
Pins 25 and 50
Inside of MSD-5404
When external power is used.
169
External power
(DC +48V max)
Advertisement
Table of Contents
