Table of Contents
Advertisement
Setup – Before Use
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Components and Controls
Front
Wire
Safety
Guard
Ignition
Hole
Tank Collar
Bracket
Hose
Mounting
Bolt
Propane Tank (not included)
Assembly / Mounting
1. Slide the Support Bar with attached
Burner Assemblies into the slots on the
top end of the Tank Collar Bracket (the
end away from the Mounting Bolt).
2. Align the two holes at the top of the Bracket with the holes in
the Support Bar. Secure in place using two Bolts and Nuts.
3. Align the slots on the bottom of the Tank Collar Bracket
with the collar ring on the propane tank (not included),
making sure the Mounting Bolt is to the outside as
shown in Figure A. Slide assembly down onto the tank
collar ring and tighten the Mounting Bolt securely.
4. Turn the Regulator Knob to the OFF position, then
align the threads on the Regulator Connector Nut
with the threads on the tank valve outlet fitting.
5. Screw the Regulator Connector Nut onto the
tank valve outlet fitting and tighten securely.
Page 8
Support Bar
Tank collar ring
For technical questions, please call 1-888-866-5797.
Burner
Assembly
Thermocouple
Safety
Shutoff
Valve
Regulator
Knob
Tip-Over
Switch
Bolts
Tank Collar
Bracket
Mounting
Bolt
Propane Tank
(not included)
Rear
Wire
Safety
Guard
Support
Bar
Regulator
Connector
Tank collar
Item 63072
Nut
ring
- Quick Links:
- Components and Controls
Hide quick links:
Advertisement
Table of Contents
