Table of Contents
Advertisement
Service and Repairs
Cutting Unit Lift Cylinder
g241355
1.
Impact arm assembly
2.
Lift cylinder
3.
Lift arm (RH shown)
4.
Grease fitting (2 each)
Removing the Cutting Unit Lift Cylinder
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
5.
Snap ring (2 each)
6.
Washer (2 each)
7.
Pin
8.
Lift arm pin assembly
Note: Refer to
Figure 28
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
Note: Read the general precautions for removing and installing the hydraulic
system components.
2. To prevent contamination of hydraulic system during the lift cylinder removal,
thoroughly clean exterior of the cylinder and fittings.
Figure 28
10.
11.
during this procedure.
Page 4–9
9.
Bolt
Lift cylinder pin assembly
Bolt
Hydraulic System: Service and Repairs
- Quick Links:
- Rollers
Hide quick links:
Advertisement
Chapters
Table of Contents
