Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for U-Fairy G.R. IOT Tech GR-309N
- Page 1 Door/Window sensor GR-309N G R · S M A R T H O M E ...
-
Page 2: Maintenance
Product Introduction The door sensor (GR-309N) is using Z - Wave technology which is a new wireless communication technology base on radio frequency . -
Page 3: Product Specification
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. Product Specification Installation Method: Magnetron Working Voltage... -
Page 4: Installation Instructions
constant magnetic field. The bigger one is the magnetometer detector,the main part. It has an internal open type magnetron. When the permanent magnet and magnetron approach to very close distance, less than 5 mm, the, door magnetic detector will turns to standby status. - Page 5 " Picture One " Picture Two...
- Page 6 " Picture Three Products Usage Z-Wave Controller Products Networking This product should be used in together with Z-Wave controller. Door sensor cell phone 门磁 GR-100 " Z-Wave install...
- Page 7 button Inclusion(Add) / Exclusion(Remove) Inclusion(Add) : press the Z-Wave button 1 time in the door sensor when the Z-Wave controller sends the instructions for inclusion or Add new devices. Exclusion(Remove): press the Z-Wave button 1 time in the door sensor when the Z-Wave controller sends the instructions for exclusion or Remove devices.
- Page 8 COMMAND_CLASS_BATTERY Report COMMAND_CLASS_BASIC Set COMMAND_CLASS_NOTIFICATION Report COMMAND_CLASS_DEVICE_RESET_LOCALLY Notification Device Reset Press the button 6 times the device will send the reset notification to the list node in the group 1 and erases the device memory, when the light flash is resetting success.
- Page 9 According to the requirements of the national standard GB50166-92 , the sensor need to be tested at least once in every half a year. And it need to have cleaning and maintenance in every two years for the sensor which has been fixed.
- Page 10 The product installation shall comply with the provisions of the state standard, reference GB50166-92 "code for construction and acceptance of automatic fire alarm system” Product Guarantee Card Customer Name Product type GR-309N Telephone Post Code Customer Address Purchasing Date Repair Content...
- Page 11 repair if consumer can provide guarantee card and purchase receipt. Please pay your attentions for the following things, Under one year guarantee period base on the date of manufacture, we will be responsible for free repair or replacement. We only charge the repair fee if it is over one year guarantee period .