Table of Contents
Advertisement
Remote control
The remote does not function.
• For receiver operation, you can only use
the DISPLAY button when the TUNER
input is selected.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
a)
Except for models of area code MX, E51, AR.
b)
Models of area code CEL, CEK only.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "Error and warning
codes" (page 25) to solve the problem.
PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
56
GB
b)
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 22). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
See
page 22
page 44
Hide quick links:
Advertisement
Table of Contents
