Connecting A N20Xx Switch To A Power Source - Dell N2024 Getting Started Manual
Hide thumbs
Also See for N2024:
- Configuration manual (1460 pages) ,
- Firmware upgrade (21 pages) ,
- Installation manual (49 pages)
Table of Contents
Advertisement
Available languages
Available languages
3 Connect the RJ-45 connector on the cable directly to the switch console
port. The Dell Networking console port is located on the right side of the
front panel and is labeled with a |O|O| symbol, as shown in Figure 1-10
on page 22.
NOTE:
serial port via the local CLI. Only one serial console session at a time is
supported.
Figure 1-10. N2024P Front Panel with Console Port
Connecting a N20xx Switch to a Power Source
CAUTION:
manual as well as the safety information for other switches that connect to or
support the switch.
All N20xx models have one internal power supply. The power receptacles are
on the back panel.
AC and DC Power Connection
1 Make sure that the switch console port is connected to a VT100 terminal
or VT100 terminal emulator via the RJ-45 to DB-9 female cable.
2 Using a 5-foot (1.5 m) standard power cable with safety ground connected,
connect the power cable to the AC main receptacle located on the back
panel (see Figure 1-11 on page 23).
3 Connect the power cable to a grounded AC outlet.
22
Getting Started Guide
Serial console access to the stack manager is available from any
Read the safety information in the Safety and Regulatory Information
Console Port
Hide quick links:
Advertisement
Chapters
Table of Contents
