hit counter script

Dubbing (From Tape 1 To Tape 2) - Tascam D00935220B Owner's Manual

Tascam double auto reverse cassette deck owner's manual
Table of Contents

Advertisement

IMPORTANT SAFETY PRECAUTIONS
4 − Recording

Dubbing (from TAPE 1 to TAPE 2)

1. Insert a cassette tape for playback into the
TAPE 1 compartment and a cassette tape for
recording into the TAPE 2 compartment.
2. Set the tape transport direction on both decks.
If the play/record direction indicator (
display points in the direction opposite to the one
desired, press the
PAUSE
(
or
) corresponding to the desired direction.
˙
¥
After changing the tape transport direction, be
sure to press the
STOP
pause mode.
NOTE
Be careful not to press play key whose arrow
points in the same direction as the indicator.
Doing so will start playback.
Set the REV MODE switch as required.
You don't need to adjust the recording level or
set the Dolby NR system, as both depend on the
pre-recorded source tape.

TASCAM 202
IV
MK
Side "A" facing you
/
) on the
˙
¥
key followed play key
key ( H ) to get out of the
3. Press either
DUB START
For normal speed dubbing, press the
key. For high-speed dubbing, press the
NOTE
High-speed dubbing makes a copy at approxi-
mately two times the normal speed. We rec-
ommend normal speed dubbing for best audio
quality.
During dubbing, either the
indicator lights steadily on the display.
During normal speed dubbing, only the following
keys work:
TAPE 1 deck:
STOP
TAPE 2 deck:
PAUSE
During high-speed dubbing, only the
( H ) works.
Pressing the
STOP
key ( H ) on either deck stops
both tapes at once.
Neither
key works immediately after
DUB START
the tape is fast-forwarded or rewound to the end.
Wait for 5 seconds or more before pressing the
key.
NOTE
During dubbing, the pitch control does not
work.
Recording level adjustment is not necessary for
dubbing, as the recording level is set to the lev-
el of the pre-recorded tape. Operating the REC
LEVEL control, before or after starting dubbing,
has no effect at all.
If a nearby television set is switched on during
high-speed dubbing, a high-pitched interfer-
ence noise may be recorded on the tape. To
avoid this, either perform dubbing at normal
speed, or turn off the television.
key to start dubbing.
NORMAL
key.
HIGH
or
NORM DUB
HIGH DUB
,
REC MUTE
,
STOP
STOP
key

Advertisement

Table of Contents
loading

This manual is also suitable for:

202mkiv

Table of Contents