Pre-Installation Requirements; Installation Checklist; Exhaust Venting; Electric Dryer - Electrolux 300 Series Use & Care Manual
Front load dryer
Hide thumbs
Also See for 300 Series:
- Use & care manual (100 pages) ,
- Installation instructions manual (50 pages) ,
- Owner's manual (11 pages)
Table of Contents
Advertisement
Pre-Installation Requirements
Exhaust Venting
ˆ Free-flowing, clear of lint buildup
ˆ 4 inch (102 mm) rigid metal or
semi-rigid metal transition ducting
of minimal length and turns
ˆ NO foil or plastic venting material
ˆ Approved vent hood exhausted to
outdoors
Leveling
ˆ Dryer is level, side-to-side and front-
to-back
ˆ Cabinet is sitting solid on all corners
Gas Supply (Gas Dryer)
ˆ Manual shutoff valve present in
Tools and materials needed for installation:
supply
ˆ All connections sealed with approved
sealer and wrench tight
ˆ Conversion kit for LP GAS system
ˆ Gas supply turned on
ˆ No leaks present at all connections
- check with soapy water, NEVER
check with flame
Water Hookup (Select Models)
ˆ Inspect hoses for proper placement
of rubber washers
ˆ Water supply is turned on
ˆ Check for leaks
ˆ Steam model dryers require use of
ASSEMBLY HOSE KIT #5304495002
(not included) and must be
purchased separately.
Installation Checklist
240v Electric Supply
(Electric Dryer)
ˆ Approved NEMA 10-30 or 14-30
service cord with all screws tight on
terminal block
ˆ Approved strain relief installed
ˆ Terminal access cover installed
before initial operation
Door Reversal
ˆ Follow detailed instructions in this
guide
ˆ Test hinge and latch for function
Electrical Power
ˆ House power turned on
ˆ Dryer plugged in
Final Checks
ˆ Installation Instructions and Use &
Care Guide read thoroughly
ˆ Door latches and drum tumbles
when cycle starts
ˆ Registration card sent in
9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
