Replacing The System Backplane - IBM Power Systems 9009-41A Manual
System backplane
Hide thumbs
Also See for Power Systems 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 66. Replacing the TPM card
d) Push the TPM card into place until it is fully seated in the new system backplane.
Replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H
Follow these steps to replace the system backplane.
About this task
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Install the replacement system backplane.
a) Grasp the replacement system backplane by positions (A) and (B) on the front and middle metal
bulkheads and begin lowering the backplane into the chassis. As you lower the backplane, be
careful not to hit the pins (C) on the power supply cage. See the following image.
68 Power Systems: System backplane
- Quick Links:
- Preparing the System for Operation
Hide quick links:
Advertisement
Table of Contents
