Replacing The Processor - Siemens SIMATIC IPC1047 Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC1047:
- Quick install manual (2 pages) ,
- Operating instructions manual (136 pages)
Table of Contents
Advertisement
Device maintenance and repair
7.5 Removing and installing hardware
Removal
1. Use the LEDs to determine which
2. Alternatively, shut down the device.
3. Acknowledge the warning signal on the
4. Tilt the handle
5. Unlock the power supply module at the
6. Slide the new power supply module
7. Reconnect the power plug
Both LEDs
7.5.4
Replacing the processor
Requirement
● The device is opened.
● A suitable processor
Only an approved processor is permitted to be installed on the motherboard of the
device. If the processor type is changed, the BIOS must be updated so that the suitable
microcode is loaded. Information about original spare parts for SIMATIC IPCs is available
on the Internet at:
– Contacts (http://www.siemens.com/automation/partner)
– SIMATIC IPC after-sales information system (http://www.siemens.com/asis)
88
module is defective, e.g. the LED
lights red.
①
The LED
can also flash red
because there is a warning, e.g.
overload.
Disconnect the power plug
power supply module to be replaced.
④
LED
.
⑥
forward.
③
pin
and pull the module
forward out of the frame by the handle
⑥
.
into the frame all the way to the rear
until it clicks into place.
Alternatively, restart the device.
①
④
and
light in green again.
④
②
from the
⑤
straight
②
.
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047
Advertisement
Table of Contents
