Supported Knx Tools; Ets; Parameter Settings In Ets - Siemens RDG100KN Basic Documentation
With knx communications
Hide thumbs
Also See for RDG100KN:
- Basic documentation (86 pages) ,
- Manual (21 pages) ,
- Instructions manual (15 pages)
Table of Contents
Advertisement
ETS
Note!
STOP
Notes
106 / 132
Siemens
Building Technologies
5.
Supported KNX tools
5.1
ETS
ETS is an engineering tool and is used to fully commission the RDG.. KNX room
thermostats.
ETS can implement the following functions:
– Define and download the physical address
– Define and download the application (plant type, control sequence)
– Set up and download the thermostat's control parameters
– Set up and download group addresses
This document does not describe how to operate ETS and how to set up a device.
Refer to the KNX Manual [4] for more details.
Setting RDG.. KNX parameters is only supported by ETS.
ETS can be updated online.
5.1.1
Parameter settings in ETS
1.
Open the project in ETS and select a device.
2.
Click Parameters tab, and adjust the control parameters as follows:
3.
The Plant type (application), Control Sequence and other control
parameters ([Pxx] description) can be downloaded.
For more details on control parameters, see 3.14.
· ETS 4 or higher version is used to assign the communication objects to group
addresses (S-Mode)
· ETS 4 or higher version is used to download the application and parameters
· The humidity parameters are only available in RDG165KN
RDG100KN, RDG160KN, RDG165KN Basic Documentation
CE1P3191en
2018-07-03
- Quick Links:
- Temperature Control
- Operating Modes
Hide quick links:
Advertisement
Table of Contents
