Products must be used, installed and operated in accordance with this manual. You may not be able to claim on the AEG manufacturer’s warranty in the event that your product fault is due to failure to adhere to this manual.
ENGLISH Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not operate the appliance by means of an external • timer or separate remote-control system. WARNING: Unattended cooking on a hob with fat or • oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch •...
ENGLISH 3. SAFETY INSTRUCTIONS 3.1 Installation • Make sure that the electrical information on the rating plate agrees WARNING! with the power supply. If not, contact Only a qualified person must an electrician. install this appliance. • Make sure the appliance is installed correctly.
3.3 Use WARNING! Risk of damage to the WARNING! appliance. Risk of injury, burns and electrical shock. • Do not keep hot cookware on the control panel. • Remove all the packaging, labelling • Do not put a hot pan cover on the and protective film (if applicable) glass surface of the hob.
ENGLISH • Cut off the mains electrical cable • Use original spare parts only. close to the appliance and dispose of 3.6 Service • To repair the appliance contact an Authorised Service Centre. 4. INSTALLATION units and work surfaces that align to the WARNING! standards.
Page 8
2 mm min. 2 mm < 20 mm > 20 mm min. 500 mm min. 500 mm 30 mm 12 mm 57 mm 12 mm 57 mm 28 mm 41 mm 28 mm 41 mm 38 mm 31 mm...
ENGLISH 4.5 Protection box If you use a protection box (an additional accessory), the front airflow space of 2 mm and the protective floor directly below the hob are not necessary. The protection box accessory may not be available in some countries. Please contact your local supplier.
Page 10
Sensor Function Comment field STOP+GO To activate and deactivate the function. Heat setting display To show the heat setting. Timer indicators of cooking To show for which zone you set the time. zones Timer display To show the time in minutes.
ENGLISH 5.4 OptiHeat Control (3 step The induction cooking zones make the heat necessary for cooking process Residual heat indicator) directly in the bottom of the cookware. The glass ceramic is heated by the heat WARNING! of the cookware. There is a risk of burns from residual heat.
Refer to “Technical data” the same time. chapter. 6.5 Grill Function To activate the function for a cooking zone: touch comes on. Use this function with the Maxisense Plancha Grill To deactivate the function: change the accessory.
ENGLISH 6.10 Lock To set the cooking zone: touch again and again until the indicator of a You can lock the control panel while necessary cooking zone comes on. cooking zones operate. It prevents an accidental change of the heat setting. To activate the function: touch Set the heat setting first.
To confirm your selection wait until the zones connected to a single phase hob deactivates automatically. exceeds 3700 W. • The function decreases the power to When the function is set to you can the other cooking zones connected to hear the sounds only when: the same phase.
Page 15
ENGLISH 7.4 Examples of cooking cookware is made of different materials (sandwich construction). applications • humming: you use high power level. • clicking: electric switching occurs. The relation between the heat setting • hissing, buzzing: the fan operates. and the cooking zone consumption of The noises are normal and do not refer power is not linear.
8. CARE AND CLEANING If not, the dirt can cause damage to WARNING! the hob. Take care to avoid burns. Put Refer to Safety chapters. the special scraper on the glass surface at an acute angle and move 8.1 General information the blade on the surface.
Page 17
ENGLISH Problem Possible cause Remedy There is water or fat stains Clean the control panel. on the control panel. An acoustic signal sounds You put something on one Remove the object from the and the hob deactivates. or more sensor fields. sensor fields.
Page 18
Problem Possible cause Remedy There is an error in the hob. Disconnect the hob from the and a number come on. electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again.
ENGLISH 10. TECHNICAL DATA 10.1 Rating plate Model HK874400FB PNC 949 595 198 01 Typ 60 GBD CC AU 220 - 240 V 50 - 60 Hz Induction 7.4 kW Made in Germany Ser.Nr....7.4 kW 10.2 Cooking zones specification...
This document sets out the terms and meaning. conditions of the product warranties 2. Application: This warranty only for AEG Appliances. It is an important applies to new Appliances, document. Please keep it with your purchased and used in Australia or...
Page 21
ENGLISH replaced Appliances or parts where the Appliance has become the property of Electrolux. been used for any non- 5. Travel and transportation costs: domestic purpose; Subject to clause 7, Electrolux will – the Appliance is modified bear the reasonable cost of without authority from transportation, travel and delivery of Electrolux in writing;...
Page 22
Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aeg.com/au FOR SERVICE FOR SPARE PARTS or to find the address of your nearest au- or to find the address of your nearest spare...