Advertisement
Quick Links
INSTALL GUIDE
KE-4 KEYLESS ENTRY SYSTEM
U.S.A. Model
WWW.ULTRASTARTERS.COM
Technical Support 866-698-5872 ext 0
Support@ultrastarters.com
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance
void the user's authority to operate this devise.
Advertisement
Related Manuals for Ultra Start KE-4
Summary of Contents for Ultra Start KE-4
- Page 1 INSTALL GUIDE KE-4 KEYLESS ENTRY SYSTEM U.S.A. Model WWW.ULTRASTARTERS.COM Technical Support 866-698-5872 ext 0 Support@ultrastarters.com FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 2 KE-4 Table Of Contents... Page 2 System Contents. Pre-Installation. Installation Tips. Main Wiring Diagram... Page 3 Quick Start Installation... Page 4 Wiring Description. Transmitter Operation. Transmitter Programming... Page 5 System Reset Quick View Programming Chart System Programming... Page 6 System Programming... Page 7 Relay Diagrams...
- Page 3 500ma Output (-) Horn Honk 500ma Output Starter Kill (+) 500ma Output Antenna - Do Not Ground the ***500ma outputs are low current and are designed to activate relays White Black Yellow Pink Blue Green Gray Brown Orange antenna wire. KE-4...
- Page 4 KE-4 STEP 1 - The following wires MUST be connected for proper operation. 12vt Power Yellow Ignition White Park Lights Black Ground G reen Lock Output Blue Unlock Output (-)500ma Output Optional Connections Orange St.Disable (-)500ma Output Connect to Starter Disable relay.
- Page 5 Ignition Aouto Door Locks Door Lock Pulses Double Pulse Passive Warning Chirps Reset To Factory Defaults Lock-Unlock-Lock-Unlock Unlock-Trunk-Unlock-Trunk Passive Lock-Trunk-Lock-Trunk Lock-Unlock-Trunk-Lock Unlock-Trunk-Unlock-Lock Lock-Trunk-Unlock-Trunk Trunk-Lock-Unlock-Trunk KE-4 Passive Active Active Three Second .75 Second Double Pulse Single Pulse Three flashes Three Flashes...
- Page 6 KE-4 Entering The Program Menu 1) Make sure ignition is in the OFF position. 2) Turn the ignition key ON - leaving key in the ON position. 3) Press the transmitter button in the appropriate sequence. 4) After ten seconds the system will automatically exit Program Mode.
- Page 7 1 Turn the ignition on. Ignition on means normal driving position. 2 Within 10 seconds, press and release the transmitter button Trunk Lock Unlock Trunk in succession. Reset to factory default is confirmed with three horn chirp sounds and three park Light flashes. KE-4...
-
Page 8: Starter Kill
KE-4 POSITIVE TRUNK RELEASE Trunk Release Switch NEGATIVE PARK LIGHTS Parking Light Switch STARTER KILL Start Start Installation Manual Grey White Orange Trunk Release Solenoid +12V Parking Lights Ground To Starter Motor or Relay...