Table of Contents
Advertisement
KBefore using for the first
time
I n this section, you can find out what you must do
B e f o r e u s i n g f o r t h e f i r s t t i m e
before using your oven or hob to prepare food for the
first time. Read the following section beforehand.
~ "Important safety information" on page 5
Remove the appliance packaging and dispose of it
appropriately.
Baking out the oven
Precleaning the oven
Remove accessories and hook-in racks from the
1.
cooking compartment.
Fully remove any remaining packaging, such as
2.
small pieces of polystyrene, from the cooking
compartment.
Some parts are covered with a protective film.
3.
Remove the protective film.
Clean the outside of the appliance with a soft, damp
4.
cloth.
Clean the cooking compartment with hot soapy
5.
water.
Heating up the oven
To remove the new cooker smell, heat up the oven
when it is empty and closed.
Turn the temperature selector to the maximum
1.
temperature.
Switch off the oven after 45 minutes.
2.
Cleaning the burner caps and cups
Clean the burner caps (A) and cups (B) with water
1.
and washing-up liquid.
Dry the parts well.
2.
Place the burner cup (B) onto the burner (C).
3.
Position the burner cap (A) exactly on the burner
4.
cup (B).
Cleaning the accessories
Before using the accessories, clean them thoroughly
using a cloth and warm soapy water.
Before using for the first time
1Operating the appliance
Y ou have already learnt about the controls and how
O p e r a t i n g t h e a p p l i a n c e
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Hob
Switching on the gas burner
Notes
Appliances with a hob cover must only be switched
■
on if the hob cover is open.
The burner caps must always be positioned exactly
■
on top of the burner cups. The slots on the burner
cup must be free from obstruction. All parts must be
dry.
Ensure that the burner is not subjected to draughts
■
caused by air conditioning systems, fans or similar
appliances.
Press the control knob for the required burner and
1.
turn it to the
position.
—
The gas burner ignites.
Keep the control knob pressed for a few seconds
2.
until the flame stabilises.
Set the desired flame setting.
3.
Setting
Meaning
Economy flame, lowest power
˜
Large flame, highest power
—
The flame is not stable between positions
Always select a position between
If the flame goes out
Switch off the control knob. Wait one minute and switch
the burner on again.
:
Warning – Risk of fire!
If the flame goes out, gas will escape. Never leave the
gas burner unattended during operation. Ensure that
there are no draughts.
If the gas burner does not ignite
In the event of a power cut or damp ignition plugs, light
the gas burner with a gas lighter or a match.
Switching off the gas burner
Turn the control knob for the required hotplate to
position
.
Û
en
and
.
Û
—
and
.
—
˜
15
Advertisement
Table of Contents
