Advertisement
Quick Links
Fender Kit
Groundsmaster 7200 Series Traction Unit
Model No. 117–9170
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Fender mount
Right fender
Thread-forming screw (5/16 x 5/8 inch)
Bolt (1/4 x 5/8 inch)
Nut (1/4 inch)
Left fender
Nut (3/8 inch)
Bolt (3/8 x 3/4 inch)
Preparing the Machine
1. Position a suitable floor jack under the rear bumper
tube and raise the rear tires off the ground
Note: Position the jack stands under the rear bumper.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
1
1
2
2
2
1
2
2
(Figure
1).
Register at www.Toro.com.
Install the right fender.
Install the left fender.
1. Rear bumper tube
2. Remove the rear wheels.
3. Remove all debris from the wheel-well area, including
any debris caught in the brake assembly.
Original Instructions (EN)
All Rights Reserved *3395-948* A
Printed in the USA
Form No. 3395-948 Rev A
Installation Instructions
Use
Figure 1
2. Floor jack
Advertisement
Related Manuals for Toro 117-9170
Summary of Contents for Toro 117-9170
- Page 1 2. Floor jack 2. Remove the rear wheels. 3. Remove all debris from the wheel-well area, including any debris caught in the brake assembly. © 2015—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3395-948* A 8111 Lyndale Avenue South...
- Page 2 Installing the Right Fender 5. Use the frame mount as a template to locate and mark the other 2 fender mounting holes in the frame channel 1. Remove the bolt securing the hose clamp to the frame (Figure channel on the right side of the machine (Figure Figure 2 Figure 4...
- Page 3 Installing the Left Fender 9. Using the newly drilled holes, secure the fender mount to the frame channel with 2 thread-forming screws 1. Disconnect the cable from the negative terminal of (5/16 x 5/8 inch) as shown in Figure the battery. 2.
- Page 4 6. Loosely mount the bracket on the top of the left fender 13. Remove the jack stands and lower the machine. to the fuel-tank bracket with 2 bolts (3/8 x 3/4 inch) Note: Verify that the tires do not rub on the fenders and 2 nuts (3/8 inch) as shown in Figure when you drive the machine.