Table of Contents
Advertisement
Available languages
Available languages
Instruction for SHARP Built-in Kits EBR-99ST/EBR-9900 (W)/(SL)/(BK)/EBR-9910(SL)
Before installing a Sharp Microwave Oven, read and check the following points.
SAFETY INFORMATION
1.
Except U.K., for use in continental Europe only.
The oven must be connected to an electric circuit provided with a switch (contact gap no less than 3
mm) to disconnect the oven in case of danger. A safety-device like a fuse in the installation may be
used as a switch.
2.
Disconnect the oven from the power supply before installation.
3.
Surround
a. Make sure that the EBR-99ST/EBR-9900/EBR-9910 is the correct surround for your oven.
b. The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built
into a fitted kitchen cabinet using the surround.
c. The EBR-99ST/EBR-9900/EBR-9910 surround will become hot during oven operations when using the
heater elements. Take care to prevent burns when you use the oven.
4.
Kitchen cabinet
Prepare the kitchen cabinet as follows;
a. The kitchen cabinet must be of the following dimensions as shown in Fig. 1.
WIDTH
HEIGHT
DEPTH
b. Make sure that the back wall of the cupboard D is always fitted to ensure the correct ventilation of
the oven and that the ventilation gap C is 45 mm as shown in Figs 1 and 2.
c. The shelf of the kitchen cabinet should be made to withstand the weight of the microwave oven to
be installed and the heaviest item likely to be cooked in the microwave oven. Refer to the operation
manual for microwave oven weight.
5.
Installation near to a conventional oven
a. When a microwave oven is to be installed next to a conventional oven, sufficient space between them
should be allowed to prevent overheating as the surround can warp with excessively high tempera-
tures.
Obviously, it is important to adhere strictly to the conventional oven manufacturer's
installation instructions.
b. A built-in microwave oven must not be installed above a conventional oven otherwise the microwave
oven's cooling system may be adversely affected by hot air produced by the conventional oven.
6.
Installation near a refrigerator or freezer
a. If the microwave oven is to be installed above a refrigerator or freezer requiring back ventilation, a
ventilation duct behind the microwave oven must be provided. It is essential that the refrigerator/
freezer manufacturer's installation procedures are followed.
b. Do not install the microwave oven above a refrigerator or freezer which are ventilated at the front.
7.
Fixing
To avoid any possibility of the kitchen cabinet moving when the microwave oven is installed, it is
essential that the kitchen cabinet is fixed to the back wall.
8.
Adjustment and repair
It is dangerous for your oven to be adjusted or repaired by anyone except properly qualified service
technicians trained by Sharp.
If the appliance is ever removed from the cabinet it should be re-installed in accordance with these
instructions, which should be kept in a safe place for future reference.
The manufacturer and/or the distributors of this product cannot be held liable for any damages to
the microwave oven and/or the built-in kit caused by improper installation or adjustment.
: 560 mm - 568 mm
: 468 mm
: 550 mm - 580 mm
1
Advertisement
Table of Contents
Related Manuals for Sharp EBR-99ST
Summary of Contents for Sharp EBR-99ST
- Page 1 Make sure that the EBR-99ST/EBR-9900/EBR-9910 is the correct surround for your oven. b. The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built into a fitted kitchen cabinet using the surround.
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS 1. (For U.K. use) A cut-out will have to be provided in the side of the kitchen cabinet for the plug of the oven. N.B.The mains plug must be accessible after installation or an all-pole switch disconnection must be provided with a contact separation of at least 3 mm in each pole. - Page 3 Wand befestigt werden. Einstellung und Reparatur Es ist gefährlich, das Gerät von einer anderen Person als einem autorisierten und von Sharp ausgebildeten Wartungstechniker einstellen oder reparieren zu lassen. Wenn das Gerät aus einem Einbauschrank entfernt wird, muss es bei Wiedereinbau entsprechend dieser Anleitung installiert werden.
- Page 4 INSTALLATIONSANLEITUNG 1. (Für Großbritannien) Für den Netzstecker muss auf der Seite des Einbauschrankes eine Öffnung gebohrt werden. Hinweis: Der Hauptnetzstecker muss nach der Installation zugänglich sein oder es muss ein Abtrennschalter vorhanden sein, bei dem die Kontakte an jedem Pol mindestens 3 mm voneinander entfernt sind.
- Page 5 S'assurer que le lot EBR-99ST/EBR-9900/EBR-9910 est le cadre qui convient au four. b. Les fours à micro-ondes de marque SHARP sont conçus pour être installés soigneusement sur le haut d'une armoire de cuisine ou montés dans un placard de cuisine convenable avec utilisation du cadre.
-
Page 6: Instructions Pour L'installation
INSTRUCTIONS POUR L'INSTALLATION 1. (Pour l'emploi au Royaume-Uni) Une petite découpe devra être prévue sur le côté du placard de cuisine pour pour la fiche du cordon d'alimentation. N.B.: La prise secteur doit être accessible après installation, ou encore un disjoncteur multipolaire doit être prévu, disjoncteur pour lequel la distance entre contacts est au moins de 3 mm. - Page 7 Aanwijzingen voor de SHARP inbouwkit EBR-99ST/EBR-9900 (W)/(SL)/(BK)/EBR-9910(SL) Lees de volgende punten goed door en controleer dat aan deze punten wordt voldaan alvorens een Sharp magnetronoven te installeren. VEILIGHEIDSINFORMATIE Uitsluitend voor gebruik in Europa (uitgezonderd Groot-Brittannië). De oven moet op een stopcontact met schakelaar worden aangesloten (contactspleet niet minder dan 3 mm) zodat u de oven bij problemen snel kunt ontkoppelen.
- Page 8 AANWIJZINGEN VOOR INSTALLATIE 1. (Voor gebruik in Groot-Brittannië) Er dient een uitsparing voor de stekker van de oven in het zijpaneel van de keukenkast te worden gemaakt. Belangrijk: Zorg dat de netstekker na de installatie toegankelijk is of dat er een twee-pool onderbrekingsschakelaar in het circuit is opgenomen met een contact-spleet van minstens 3 mm in iedere pool.
- Page 9 Accertatevi che l'EBR-99ST/EBR-9900/EBR-9910 sia il telaio corretto per il vostro forno. b. I forni a microonde Sharp sono progettati per essere installati comodamente su un ripiano della cucina, oppure per essere incorporati all'interno di un armadietto della cucina usando il telaio.
-
Page 10: Istruzioni Per L'installazione
ISTRUZIONI PER L'INSTALLAZIONE 1. (Per l'uso in Gran Bretagna) Sul fianco dell'armadietto da cucina si deve praticare una apertura per la spina del cavo di alimentazione. Nota Bene: La spina di corrente deve essere accessibile dopo l'installazione, oppure bisogna provvedere un interruttore automatico multipolare con una distanza tra i contatti di almeno 3 mm. - Page 11 Instrucciones para la Instalación del Juego de Piezas del Bastidor SHARP EBR-99ST/EBR-9900 (W)/(SL)/(BK)/EBR-9910(SL) incorporado Antes de instalar el Horno de Microondas Sharp, sírvase leer y comprobar los puntos que se mencionan a continuación. NOTAS PARA MAYOR SEGURIDAD DEL HORNO Para uso en Europa continental solamente, excluyendo el Reino Unido.
-
Page 12: Instrucciones De Instalacion
INSTRUCCIONES DE INSTALACION 1. (Para uso en el Reino Unido) Deberá realizarse un corte en el lado del armario de cocina para la clavija del horno. Nota: La clavija de conexión a la red eléctrica deberá quedar accesible después de realizar la instalación, o deberá... - Page 13 EBR-99ST/EBR-9900(W)/(SL)/(BK)/EBR-9910(SL) Fig. 1 Shelf of kitchen cabinet Boden des Einbauschrankes Tablette du placard de cuisine Plank van keukenkast Ripiano armadietto da cucina Estante del armario de cocina For Continental use only Nur f r Verwendung in Kontinental-Europa Pour l«utilisation sur le Continent seulement Uitsluitend voor gebruik in Europa Per l’uso nell’Europa continentale soltanto Esta unidad est dise ada exclusivamente para uso en...
-
Page 14: Installation
Fig. 7 Fig. 8-a Fig. 8-b Fig. 9 Fig. 10 Fig. 11 60mm 596mm 552mm 22mm Kitchen cabinet door Einbauschranktür Porte du placard de cuisine Deur van keukenkast Sportello armadietto da cucina Puerta del armario de cocina Kitchen cabinet door Einbauschranktür Porte du placard de cuisine Deur van keukenkast... - Page 15 Legend = Built-in frame (complete) = Microwave oven = Ventilation gap = Back panel = Fastening screw = Spacing bracket = Exhaust duct = Exhaust duct = Intake duct = Intake duct = Cushion (490 mm x 15 mm) = Cushion (400 mm x 14 mm) = Cushion (990 mm x 15 mm) = Cushion (580 mm x 66 mm) = Built-in frame top element...
- Page 16 - Kun til kontinentalt brug undtagen U.K. Hvis apparatet skal bruges hjemme, skal der bruges en hel-pols afbryder (med en afstand på mere end 3 mm) fro at afbryde ovne fra strømtilføuirslen. Ex. afbryder til sikring. SHARP CORPORATION Osaka, Japan Recycled paper / Printed with soy ink Recyclingpapier / Gedruckt mit Sojafarbe Papier recyclé...