Related Manuals for Toro 22445
Summary of Contents for Toro 22445
- Page 1 Form No. 3396-718 Rev A 40in Tiller Compact Utility Loader Model No. 22445—Serial No. 260000001 and Up *3396-718* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
................6 Adjusting Tiller Drive Chain Tension ......6 Replacing the Tiller Tines ......... 7 This tiller is intended to be used on a Toro compact utility Storage ................. 8 loader. It is designed primarily for breaking through hard soil Troubleshooting ............ -
Page 3: Safety
• Ensure that the attachment mount plate is free of To ensure optimum performance and continued safety any dirt or debris that may hinder the connection certification of the machine, use only genuine Toro of the traction unit to the attachment. replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, •... -
Page 4: Safety And Instructional Decals
Contact your Authorized Service Dealer or Safety and Instructional Distributor or go to www.Toro.com for a list of all approved attachments and accessories. Decals To best protect your investment and maintain optimal... -
Page 5: Operation
Operation Refer to your traction unit Operator’s Manual for more information on installing and removing attachments on your traction unit. Important: Always use the traction unit to lift and move the attachment. • Clean the area of trash, branches, and rocks before tilling to prevent equipment damage. -
Page 6: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Lubricate the chain tension. After the first 5 hours • Adjust the chain tension. • Check the tines (replace as required). Before each use or daily • Check and tighten the tine bolts (replace as required). •... -
Page 7: Replacing The Tiller Tines
2. Torque the tine-mounting bolts to 85 to 104 N-m (63 to 77 ft-lb). Figure 2 1. Adjuster bolt 3. Chain-drive cover 2. Hydraulic motor, mount-plate bolt 5. After you have set the chain to the proper tension, tighten the adjuster bolt and hydraulic motor mount-plate bolts (Figure Note: When you can no longer set the chain to the... -
Page 8: Storage
Storage 1. Before long term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Check the condition of the drive chain. Adjust and lubricate the chain. 3. Grease all fittings. 4. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn parts. -
Page 9: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The tiller does not operate. 1. A hydraulic coupler is not completely 1. Check and tighten all couplers. connected. 2. One or more hydraulic couplers are 2. Check the couplers and replace any damaged. that are damaged. - Page 10 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 11 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 12 Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.