Toro TX 1000 Operator's Manual
Adjustable forks compact tool carriers
Hide thumbs
Also See for TX 1000:
- Operator's manual (60 pages) ,
- Installation instructions manual (8 pages) ,
- Installation instructions (4 pages)
Related Manuals for Toro TX 1000
Summary of Contents for Toro TX 1000
- Page 1 Form No. 3420-668 Rev C Adjustable Forks TX 1000 Compact Tool Carriers Model No. 22341—Serial No. 401900000 and Up *3420-668* C Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Contents Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model Safety ............... 3 and serial numbers of your product ready. Figure 1 General Safety ........... 3 identifies the location of the model and serial numbers Slope Safety ............ -
Page 3: Safety
Slope Safety Safety • Operate the machine up and down slopes with the heavy end of the machine uphill. Weight General Safety distribution changes with attachments. An empty attachment makes the rear of the machine the Always follow all safety instructions to avoid serious heavy end, and a full attachment makes the injury or death. -
Page 4: Attachment Safety
Attachment Safety Safety and Instructional Decals • Always lower the attachment each time you shut off the machine or leave the operating position. Safety decals and instructions are • Clean any dirt or debris that may hinder connecting easily visible to the operator and are the attachment to the machine. -
Page 5: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Adjustable-forks frame Fork Upper fork frame Assemble the forks. Bolt (3/8 x 1 inch) Locknut (3/8 inch) Assembling the Forks Parts needed for this procedure: Adjustable-forks frame Fork Upper fork frame... -
Page 6: Product Overview
Product Overview Operation Note: Always use the traction unit to lift and move the attachment. Important: Before installing the attachment, ensure that the mount plates are free of any dirt or debris and that the pins rotate freely. If the pins do not rotate freely, grease them. -
Page 7: Storage
Storage Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. Store the attachment in a clean, dry garage or storage area.