hit counter script
Toro GrandStand 74536 Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. GrandStand 74536
  6. Setup instructions
Toro GrandStand 74536 Setup Instructions

Toro GrandStand 74536 Setup Instructions

Hide thumbs Also See for GrandStand 74536:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

GrandStand
Model No. All GrandStand Mowers
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
™
Mowers
Description
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
Operator's Manual
Engine Owner's Manual
Registration Card
Operator training material
Key
Oil drain hose
Register at www.Toro.com.
Form No. 3360-902 Rev C
Qty.
–
Check the tire pressure.
–
Prepare the grass deflector.
–
Check the engine oil level.
–
Add fuel to the machine.
–
Check the hydraulic oil level.
–
Install the battery cables.
–
Charge the battery.
Check the machine before delivery to
–
the customer.
1
1
1
Delivering the machine to the customer.
1
1
1
Setup Instructions
Use
Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro GrandStand 74536

Summary of Contents for Toro GrandStand 74536

  • Page 1 Engine Owner’s Manual Registration Card Delivering the machine to the customer. Operator training material Oil drain hose Register at www.Toro.com. © 2008—The Toro® Company Original Instructions (EN) 8111 Lyndale Avenue South Printed in the USA. Bloomington, MN 55420 All Rights Reserved...

  • Page 2: Checking The Tire Pressure

    Checking the Tire Pressure Checking the Engine Oil Level No Parts Required No Parts Required Procedure Procedure Pressure: 12 to 14 psi (83 to 97 kPa) Before you start the engine and use the machine, check the oil level in the engine crankcase; refer to Checking Note: The front caster wheel is a semi-pneumatic tire the Engine Oil Level in the Operator’s Manual.

  • Page 3: Charging The Battery

    Installing the Battery Cables Charging the Battery No Parts Required No Parts Required Procedure Procedure 1. If not installed, install the positive (red) battery cable to the positive (+) battery terminal with a nut, washer and bolt. Slide the rubber cover over the post. Charging the battery produces gasses that can 2.
  • Page 4 Checking the Machine Before Delivery to the Customer No Parts Required Procedure Before delivering the machine to the customer, ensure that you perform or have performed the procedures listed in the following table and initial each when finished. Refer to the Operator’s Manual for instructions on performing these procedures.
  • Page 5 Make sure that the customer receives the Operator’s Manual, Engine Owner’s Manual, Set Up Instructions, and operator training material. Make sure the customer knows the Parts Catalog is available at www.Toro.com. Assist the customer in loading the mower. Note: When you, the dealer representative, have finished delivering the machine to the customer, sign and date in the space provide below and keep a copy of this page for dealer records.
  • Page 6 Notes:...
  • Page 7 Notes:...

Table of Contents