Variable Angle Bracket - Pioneer XY Series Installation Manual
Hide thumbs
Also See for XY Series:
- Installation manual (77 pages) ,
- User manual (15 pages) ,
- User manual (11 pages)
Table of Contents
Advertisement
3 Rigging And Caster Setting
__________________________________________________________________________________________________________
3.2.3 Variable Angle Bracket
When using the Variable Angle Bracket, suspension of the enclosure
vertically from the ceiling as shown in the right figure is available. It is
easier to change the inclined angle of Variable Angle Bracket than that of
Vertical Flying Cradle. Speaker models compatible with respective Variable
Angle Brackets is shown in the table below:
Table.3-2-3-A: Models compatible with each Variable Angle Bracket and
the range of inclined angle
No.
Use model
CP-XY3DF1
XY-3B
CP-XY1DF1
XY-1/XY-2E
Plus
degree
WARNING:
- Do not attempt to use this product with components other than the specified speaker.
- Be sure to use the supplied accessory screws.
- Flat washer and spring washer out of the reach of children and infants. If acidentally swallowed, contact a
doctor immediately.
- After mounting the speaker with the cradle, never loosen any of its accessory installation screws, since the
speaker could fall or other accidents could occur.
- Attach two or more wires to a rigging point different from those for installing the cradle to prevent swaying.
- Variable Angle Bracket is not supposed to be used in the following situations, which may cause an injury or
accident.
Suspending from sloped
(non-horizontal) ceiling
http://pioneerproaudio.com/
Minus
degree
Suspending
from the wall
Multiple enclosures
NOTE: XY-3B is shown in the illustration.
To the ceiling
Suspending
©2020 AlphaTheta CORPORATION
Fig.3-2-3-A
Page 18 / 43
Advertisement
Table of Contents
