Table of Contents
Advertisement
12
www.aeg.com
9. BEFORE FIRST USE
Before you use the appliance for the first
time:
• Clean the tumble dryer drum with a
moist cloth.
10. DAILY USE
10.1 Start a programme
without delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you
close the door, the
laundry does not get
caught between the
appliance door and the
rubber seal.
2. Set the correct programme and
options for the type of load.
3. Press the Start/Pause touch button.
The programme starts.
10.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again
and again as necessary.
You can delay the start
of a programme by 3, 6
or 9 hours.
3. Press the Start/Pause button.
The LEDs (9H, 6H, 3H) change on each 3
hours.
10.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
10.4 At the end of the
programme
When the programme is completed:
• Start a 1 hour programme with moist
laundry.
• An intermittent acoustic signal
operates (If the Buzzer function is on).
• The indicators End and Filter comes
on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for
approximately other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter
when a programme is
completed.
10.5 Stand-by function
To decrease the energy consumption,
this function automatically deactivates
the appliance:
• After 5 minutes if you do not start the
OFF
programme.
• After 5 minutes from the end of the
programme.
OFF
Hide quick links:
Advertisement
Table of Contents
