Operation (Ltb) - Siemens SITRANS LR250 Operating Instructions Manual
Radar transmitters
Hide thumbs
Also See for SITRANS LR250:
- Operating instructions manual (306 pages) ,
- Quick start manual (272 pages) ,
- Instruction manual (175 pages)
Table of Contents
Advertisement
Operation (LTB)
Navigate to Configure/Setup > LTB > Operation.
Click on Block Modes to open the dialog window for access to:
Block Modes:
•
Actual Mode
This is the current mode of the block, which may differ from the target
based on operating conditions. Its value is calculated as part of the block
execution.
•
Target Mode (see
•
Permitted Mode
Defines the modes that are allowed for an instance of the block. The
permitted mode is configured based on application requirements.
•
Normal Mode
This is the mode that the block should be set to during normal operating
conditions.
Click on Simulation to open the dialog window for access to:
Simulation (Input)
Allows you to simulate the sensor value which is input to the Level Transducer
Block. This tests everything between the Level Transducer Block and Output.
Note: To activate simulation via AMS Device Manager or the 375 Field
Communicator, simulation must also be set to Enabled on the device. See
4. 1 2. Simulate Enable
•
Simulation
•
Simulation Value
•
RAMP start
•
RAMP end
•
RAMP No of steps
Page 50
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
(read only)
2.6.2. Mode
on page 113)
on page 128.
7ML19985KL01
Advertisement
Table of Contents
Troubleshooting
