Mounting Without Mounting Rail - Siemens SIMATIC ET 200eco PN M12-L System Manual
Hide thumbs
Also See for SIMATIC ET 200eco PN M12-L:
- Operating instructions manual (278 pages) ,
- Compact operating instructions (156 pages) ,
- System manual (127 pages)
Table of Contents
Advertisement
3.2
Mounting without mounting rail
Introduction
The ET 200eco PN M12-L distributed I/O devices are designed for installation on a level, firm
surface.
The axially symmetric drill holes allow you to fasten the I/O devices to an aluminum or carrier
profile.
The following picture shows an aluminum mounting rail on which the I/O devices can be
mounted.
Figure 3-1
Required tools
For the installation you need a screwdriver, suitable for the screws used.
Required screws
For mounting, use screws with a diameter of 5 mm and a length of at least 35 mm.
Drill holes of the I/O device
All enclosures of the ET 200eco PN M12-L distributed I/O devices have a uniform hole pattern.
The housings of the I/O devices are axially symmetric. The distance between the drill holes is
identical for all I/O devices.
Distributed I/O system ET 200eco PN M12-L
System Manual, 06/2021, A5E48753295-AC
Aluminum profile
3.2 Mounting without mounting rail
Mounting
19
Advertisement
Table of Contents
