Advertisement
Quick Links
Heritage II Digital Turn
Quick Reference Guide:
30
Control Panel Lock Out
To unlock panel:
•
Press & hold for 3 seconds to unlock control panel.
To lock panel:
•
To lock out the control panel press the Lock Out
button and all functions will be locked.
•
If the control panel is not used for a period of 30
seconds it will automatically lock out and inhibit
the use of the functions.
Comfort Control
The Soft and Firm buttons allow adjustment of
•
When pressing the Firm button, the output pressure
will increase to provide a higher pressure output
and thus increased support.
•
When pressing the Soft button, the output
pressure will be decreased to provide a lower
pressure output and thus increased comfort.
Auto-Detection -
detecting patient weight (distribution)
•
Simultaneously pressing the Soft and Firm buttons on the
control panel will manually activate Auto-Detection.
•
will start detecting the patients weight
internal pressures appropriately. The system will
continuously check this every 2 hours.
Auto Firm Mode
•
Pressing the Auto Firm
to the Max Weight Banding in order to create a
firm surface
•
The system will automatically return to
Last Mode Of Operation after 20 minutes.
Function Mode button
•
Pressing the Mode button allows you to cycle
between the different modes available such as
Alternating Static
A Full Risk Assessment should be completed before using this System
Please refer to the product User Manual for full instructions for use.
255
kg
165 205
130
100
75
50
to set
will inflate cells
Constant Low Pressure
-Please refer to User Manual for guidance
www.ultimatehealthcare.co.uk | Tel: 0333 321 8996
CLP
Mode
Alternating Mode
Alternating mode is the default mode for the
•
•
The alternating cycle will continue at the selected
cycle time until another mode is selected.
Static Mode
•
Pressing the Mode button until the Static indicator
illuminates puts the system into Static mode.
•
The system will automatically return to
Alternating mode after 20 minutes.
•
Pressing the Mode button until the CLP indicator
illuminates puts the system into Constant Low
Pressure mode.
•
Alternating Cycle Time Selection
•
•
To select press Cycle button until required cycle
time is displayed in LCD screen.
Alarms Mute
The Alarm Mute button temporarily resets the
audible Low Pressure/Power Failure/Service
alarms. Should the situation not be resolved and
the fault condition continues the alarm will resume.
Please refer to the manual for other alarms
CPR Valve -
left hand side of the mattress
In the event of a patient suffering a cardiac
arrest and CPR needing to be administered:
To activate the CPR: Pull and rotate the dial of
the CPR valve to 'click' into the OPEN position.
At the same time, disconnect the air pipe connector
from the Pump to speed up the air release.
To reset CPR: Ensure the dial of the CPR
attachment is rotated until it 'clicks' into the
CLOSED position.
Transport Mode -
•
Disconnect air pipe connector and
immediately place the cover over it.
•
Restore the mattress by reconnecting the
supply tubes to the power unit.
Mode
for up to 12 to 24 hours.
Advertisement
Related Manuals for Ultimate Healthcare Heritage II Digital
Summary of Contents for Ultimate Healthcare Heritage II Digital
- Page 1 Heritage II Digital Turn Quick Reference Guide: Please refer to the product User Manual for full instructions for use. 165 205 Mode Alternating Mode Control Panel Lock Out Alternating mode is the default mode for the • To unlock panel: •...
- Page 2 Mattress Setup Secure the mattress to the moving parts of the mattress platform Cable Management System Cable management fixings are using the securing straps, and when the system is fully inflated it located on each side of the mattress underneath the flap of the is ready for the patient to be positioned onto the mattress.