Appliances), and Underwriters Laboratories (UL characteristics as the recommended replacement part Publication UL1410, 59.7). might create shock, fire and / or other hazards. Product safety is under review continuously and new instructions are issued whenever appropriate. 1700FP...
Page 4
Use only an anti-static solder removal device. Some brushing clothes together, or lifting your foot from solder removal devices not classified as “anti-static” a carpeted floor can generate enough static can generate electrical charges sufficient to damage electricity to damage an ESD. ESDs. 1700FP...
Storage Temperature : -4°F to 113°F (-20°C to 45°C) Humidity : 5 % to 95 % • 1700FP comply with SWEDAC (MPR II) recommendations for reduced electromagnetic fields. • Designs and specifications are subject to change without prior notice. 1700FP...
Page 6
GND-B Composite H/V Sync No Connection No Connection No Connection Self Raster Self Raster DDC Data V-Sync Bi-Dr Data (SDA) Bi-Dr Data (SDA) Reserved H/V-Sync H-Sync Sync Return / Self-Test V-Sync Not Used DDC Clock (SCL) DDC Clock (SCL) 1700FP...
Page 7
B : Horizontal sync width O : Frame time total P : Vertical sync width C : Back porch D : Active time Q : Back porch R : Active time E : Front porch S : Front porch 1700FP...
3 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the 1700FP monitor. WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components. 3-1 Disassembly Cautions:1. Disconnect the monitor from the power source before disassembly.
Page 10
3 Disassembly and Reassembly Memo 1700FP...
SIGNAL CABLE BOARD VER. 2.0 3-WIRE CABLE 5V DC 5V DC ADAPTOR 3-WIRE ADAPTOR CABLE SIGNAL CABLE PARALLEL CABLE PARALLEL CABLE D-SUB SIGNAL CONNECTOR GENERATOR Figure 4-1. Setup 1, With Signal Generator Figure 4-2. Setup 2, Without Signal Generator 1700FP...
Page 12
AD Board by using the Write button. 5. Perform other procedures using the DDC Control Jig, if necessary. 6. When all procedures are complete, select the Exit button (Item 9) to quit the DDC Control Jig software. 4-2-2 (b) Color Auto Adjustment 1700FP...
Does proper DC 5 V appear at Check IC101 and related circuit. Pin 4 of IC101? Does proper 5 V - signal appear at Check IC501 and related circuit. Pin 42 of IC501 (SW_REG_EN)? (CN102, Function Key) Check Q103, Q105 and Q106. 1700FP...
Page 14
PDA, PDB)? During power on-off dose the input signal appear at the R 407 and R 408 ? Check IC501 and related circuit. (MX - SDA, MX - SCL) 1700FP...
Page 16
11 12 13 10 of IC404? CH1 RMS = 4.18V While pushing a front control button does any pulse appear Check IC404 and related circuit. at Pin 12 of IC404? CH1 RMS = 3.26V Replace IC404. CH1 RMS = 3.26V 1700FP...