Table of Contents
Advertisement
Setting a Static IP Address Using the LCD Display
By using the projector's LCD display while it is in standby mode, you can
manually set a fixed IP address without projecting any information from
the projector.
a
Make the following settings to set a fixed IP address when the
projector is in standby mode.
• Set A/V Output to Always On.
s Extended - A/V Settings - A/V Output
• Set Standby Mode to Communication On.
s Extended - Standby Mode
a
Connect the projector with a wired LAN, and then turn on the
main power switch.
b
Hold down the [HDBaseT/LAN] button on the control panel for at
least three seconds.
The static IP address setting menu is displayed on the LCD display.
a
Press the [Esc] button to cancel the settings.
c
On the control panel or the remote control, press the buttons in
the order [
], [
] to select OFF, then press the [
p.142
p.142
] button.
d
On the control panel or the remote control, use the [
buttons to change the values, use the [ ][ ] buttons to move the
input position and set the IP address, and then press the [
button.
a
You can also make settings by pressing the numeric buttons on
the remote control.
e
Continue to set the subnet mask and gateway address if necessary,
and then press the [
] button on the confirmation screen.
f
Press the [
] button to return to the status information screen.
126
][
]
]
Advertisement
Table of Contents
