Table of Contents
Advertisement
> Before Start
> Part Names
a Speaker cable
16
> Install
> Initial Setup
1/2˝
(12 mm)
a
> Playback
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
Connecting with Bi-Amping Speakers (Page 13)
Make sure you remove the jumper bar fitted between the
woofer jacks and tweeter jacks of the front speakers. Refer
to "Standard Connections (Pages 8 to 12)" (P15) to connect
the center speaker, surround speakers, and powered
subwoofer.
0 Also refer to the instruction manual for your speakers
when using connections for Bi-Amping.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P23).
0 If any of the connected speakers have an
impedance of 4 Ω or more to less than 6 Ω, after
completing Initial Setup, you need to make some
settings in the System Setup menu. Press
the remote controller, and in the Home displayed
set "System Setup" - "Speaker" - "Configuration" -
"Speaker Impedance" to "4ohms".
For high-
frequency
For low-
frequency
Make sure the exposed wires of the speakers
do not stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
on
Hide quick links:
Advertisement
Chapters
Table of Contents
