Table of Contents
Advertisement
AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
About This Chapter
3.1 Logging In to the Device Using STelnet/Telnet
3.2 Logging In to the Device Through the Web System
3.3 Logging In to the Device Through the Console Port
3.1 Logging In to the Device Using STelnet/Telnet
You can log in to the device using STelnet V2 or Telnet to configure, manage, and maintain
the device in the CLI.
Device connections are classified into wired and wireless connections.
Before logging in to the device, complete the following tasks:
The following table lists the default configuration of the device. You are advised to change the
default user name and password on your first login.
Table 3-1 Default configuration of the device
Parameter
User name
Password
Issue 01 (2017-12-29)
3
By default, only the STelnet V2 service is enabled on the device.
Telnet has security vulnerabilities. You are not advised to enable the Telnet service.
In versions earlier than V200R007C20, APs support wired connections.
In V200R007C20 and later, Fat APs support both wired and wireless connections, and
Fit APs and cloud APs support wired connections.
Power on the device.
Prepare network cables used to connect device interfaces for wired connections. No
network cable is required for wireless connections.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Logging In to the Device
Default Setting
admin
admin@huawei.com
3 Logging In to the Device
25
Advertisement
Chapters
Table of Contents
