Use only the ink cartridge specified in the table below with the power switch EPSON Stylus COLOR 300. Use EPSON ink cartridges within six months of installing them and before the expiration date on the package. Cartridge Color ink cartridge (CMYK)
Page 2
Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper. Always test samples of paper stock before purchasing large quantities or printing large jobs.
Page 3
** The ink cartridge thaws and is usable after approximately 3 hours at 77 °F (25 °C). Caution: To ensure good results, use genuine EPSON ink cartridges. Other products may cause damage to your printer not covered by EPSON’s warranty.
It may also flash with other lights during printer error conditions. 4 - EPSON Stylus COLOR 300 Ink Out Paper Out Initialization The printer can be initialized (returned to a fixed set of...
Power slightly left to the ink cartridge replacement position. Caution: To avoid damaging the printer, do not move the print head by hand. 3. Open the printer cover. 4. Lift up the ink cartridge clamp as far as it goes. Then remove the protective material from the cartridge holder.
Page 6
Caution: To ensure good results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty. Leave the old cartridge installed in the printer until you are ready to replace it with a new one.
Page 7
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in your eyes, flush them immediately with water. 4. Lift the ink cartridge out of the printer and dispose of it properly. 5. Open the ink cartridge package and remove only the yellow portion of the tape seal from the top of the cartridge.
30 sheets in the sheet feeder and set the minimum top margin to 1.2 inches (30 mm). You must load A6 size sheets one at a time. 8 - EPSON Stylus COLOR 300 Setting the Thickness Lever Then select this...
Testing the Printer You can run a printer self test to check the operation of the printer. If you encounter a printing problem, running a self test can help you determine whether the problem comes from the printer itself or some other source.
If you’re using a Windows computer connected directly to the printer, you can align the print head using the Print Head Alignment utility in your printer software. Follow these steps: 1. Turn on the printer and make sure that paper is loaded in the sheet feeder. Power light is 2.