Part number S041586 Resolution S041060 Print direction S041059 9/01 EPSON Stylus Photo 820 Size Letter (8.5 x 11 inches) A4 (8.3 x 11.7 inches) Legal (8.5 x 14 inches) A6 (4.1 x 5.8 inches) 4 x 6 inches 4 x 6 inches, non-perforated, borderless Letter (8.5 x 11 inches)
0.4 A Power consumption Approx. 17 W (ISO10561 Letter Pattern) Approx. 4 W in standby mode * Check the label on the back of the printer for your printer’s voltage. Environmental Temperature Operation 50 to 95 °F (10 to 35 °C) Storage* −...
Page 3
Always load paper into the sheet feeder short edge first, except for envelopes. Load envelopes flap edge first with the flap side down Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper.
The minimum top margin is 0.12 inch (3.0 mm). When loading multiple sheets of EPSON Photo Quality Glossy Film, the minimum top margin is 1.2 inches (30.0 mm). B-L: The minimum left margin is 0.12 inch (3.0 mm).
If the ink cartridge holders don’t move into loading position as shown, press the ink cartridge replacement button to move them. 3. Unpack the ink cartridges that came with your printer and remove the yellow tabs. black cartridge color cartridge Install both ink cartridges or the printer won’t work.
❏ Some special media have a cut corner that you need to position in the upper right corner when you load it. ❏ You can load the following number of sheets of EPSON special media: For this paper name...
To ensure good results, use genuine EPSON ink cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty. When you need new ink cartridges, contact your dealer, or call the EPSON Store at (800) 873-7766 or visit ™...
Running the Head Cleaning Utility Follow these steps to run the Head Cleaning utility: 1. Make sure the printer is turned on but not printing, and the red b error light is off. (If the red b error light is flashing or on, you may need to replace the ink cartridge;...
If you move your printer some distance, you need to prepare it for transportation in its original box or one of a similar size. 1. Turn on the printer, wait until the print head locks in the far right position, then turn off the printer.
4. Open the printer cover. If you still have the packing insert, slide it down into the area beside the ink cartridge holder and tape it to the printer case. If you don’t have the insert, just tape the cartridge holder to the printer case. Then close the printer cover.