Sony CDX-M730 Installation/Connections
Fm/am compact disk player
Hide thumbs
Also See for CDX-M730:
- Operating instruction (158 pages) ,
- Operating instructions manual (84 pages) ,
- Service manual (84 pages)
Advertisement
Quick Links
FM/AM
Compact Disc
Player
Installation/Connections
Installation/Connexions
Instalación/Conexiones
CDX-M730
CDX-M630
Sony Corporation © 2002
1
1
2
4
5
Equipment used in illustrations (not supplied)
Appareils utilisés dans les illustrations (non fournis)
Equipos utilizados en las ilustraciones (no suministrado)
Front speaker
Haut-parleur avant
Altavoz delantero
Rear speaker
Haut-parleur arrière
Altavoz posterior
Power amplifier
Amplificateur de puissance
Amplificador de potencia
3-242-100-11 (1)
Printed in Korea
3
× 2
× 4
6
CD/MD changer
Changeur de CD/MD
Cambiador de CD/MD
Active subwoofer
Caisson de graves actif
Subwoofer activo
Rotary commander RM-X4S
(CDX-M630 only)
Satellite de commande RM-X4S
(CDX-M630 uniquement )
Mando rotatorio RM-X4S
(sólo CDX-M630)
2
A
SUB OUT (MONO)
AUDIO OUT
REAR
B
BUS AUDIO IN
BUS CONTROL IN
Source selector*
Sélecteur de source*
Selector de fuente*
XA-C30
Cautions
• This unit is designed for negative ground 12 V DC
operation only.
• Do not get the wires under a screw, or caught in
moving parts (e.g. seat railing).
• Before making connections, turn the car ignition
off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all ground wires to a common ground
point.
• Be sure to insulate any loose unconnected wires
with electrical tape for safety.
• The use of optical instruments with this product
will increase eye hazard.
Notes on the power supply cord (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
For the use of release key 6, see the supplied
operating instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
Connection example (2)
Notes (2-A)
• Be sure to connect the ground cord before connecting
the amplifier.
• If you connect an optional power amplifier and do not
use the built-in amplifier, the beep sound will be
deactivated.
Tip (2-B-
)
For connecting two or more CD/MD changers, the source
selector XA-C30 (optional) is necessary.
AUDIO OUT
FRONT
BUS AUDIO IN
BUS CONTROL IN
* not supplied
non fourni
no suministrado
Connection diagram (3)
1
To a metal surface of the car
First connect the black ground lead, then connect
the yellow and red power input leads.
2
To the power antenna control lead or power
supply lead of antenna booster amplifier
Notes
• It is not necessary to connect this lead if there is no
power antenna or antenna booster, or with a
manually-operated telescopic antenna.
• When your car has a built-in FM/AM antenna in
the rear/side glass, see "Notes on the control and
power supply leads."
3
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
4
To the interface cable of a car telephone
5
To a car's illumination signal
Be sure to connect the black ground lead to it first.
6
To the +12 V power terminal which is energized
in the accessory position of the ignition key
switch
Notes
• If there is no accessory position, connect to the +12
V power (battery) terminal which is energised at all
times.
Be sure to connect the black ground lead to it first.
• When your car has a built-in FM/AM antenna in
the rear/side glass, see "Notes on the control and
power supply leads."
7
To the +12 V power terminal which is energised
at all times
Be sure to connect the black ground lead to it first.
Notes on the control and power supply leads
• The power antenna control lead (blue) supplies +12 V
DC when you turn on the tuner.
• When your car has built-in FM/AM antenna in the rear/
side glass, connect the power antenna control lead
(blue) or the accessory power input lead (red) to the
power terminal of the existing antenna booster. For
details, consult your dealer.
• A power antenna without relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected, power
will always be supplied to the memory circuit even when
the ignition key is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms, and
with adequate power handling capacities to avoid its
damage.
• Do not connect the speaker terminals to the car
chassis, or connect the terminals of the right speakers
with those of the left speaker.
• Do not connect the ground lead of this unit to the
negative (–) terminal of the speaker.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active
speakers (with built-in amplifiers) to the speaker
terminals may damage the unit.
• To avoid a malfunction, do not use the built-in speaker
wires installed in your car if the unit shares a common
negative (–) lead for the right and left speakers.
• Do not connect the unit's speaker cords to each other.
Advertisement
Related Manuals for Sony CDX-M730
Summary of Contents for Sony CDX-M730
- Page 1 BUS CONTROL IN * not supplied CDX-M630 non fourni no suministrado Sony Corporation © 2002 Printed in Korea Cautions Connection diagram (3) • This unit is designed for negative ground 12 V DC To a metal surface of the car operation only.
- Page 2 Source selector (not supplied) Sélecteur de source Supplied with the CD/MD changer (non fourni) Fourni avec le changeur de CD/MD Selector de fuente Suministrado con el cambiador de CD/MD (no suministrado) XA-C30 RCA pin cord (not supplied) Cordon à broche RCA (non fourni) REMOTE IN BUS AUDIO IN AUDIO OUT...
- Page 3 2 pour le montage. fournies Comment retirer et fixer la How to detach and attach the façade (5) (CDX-M730 Warning when installing in a car front panel (5) (CDX-M730 Avertissement en cas uniquement) without ACC (accessory) only) d’installation dans une voiture position on the ignition key Avant d’installer l’appareil, retirez la façade.
- Page 4 Existing parts supplied with your car Pièces existantes fournies avec la voiture Pièces existantes fournies avec la voiture Piezas existentes suministradas con su automóvil Piezas existentes suministradas con su automóvil CDX-M730 CDX-M630 Main display-position Sub display-position Main display-position Sub display-position Position fermée : écran d’affichage principal...