Table of Contents
Advertisement
Figure 17
1. Control bar
Seat Pivot Control
To rotate the seat, pull the seat lever up and rotate the seat
to the desired position.
Seat Belt
WARNING
Operating the machine without the rollover
protection system (ROPS) securely in place can
result in serious injury or death if the machine rolls
over.
Ensure that the roll bar is securely in place.
Always wear a seat belt with the ROPS in place.
Ensure that the operator seat is properly secured
to the machine.
Note: Regulations in some localities require that seat belts on
construction machines be 76 mm (3 inch) wide. Check with
local authorities regarding the requirements for seat belts.
•
To fasten the seat belt, insert the tab end into the left
buckle.
Note: Ensure that the tab end and the buckle are
securely fastened.
•
To release the seat belt, push the button on the buckle.
Battery-disconnect Switch
The battery-disconnect switch is located behind the right
engine cowl (Figure 18); use it to electrically disconnect the
battery from the machine.
2. Seat lever
1. Battery On position
•
Rotate the battery disconnect clockwise to the On
position.
•
Rotate the battery disconnect counterclockwise to the
Off position.
Specifications
Note: Specifications and design are subject to change
without notice.
Basic Machine Dimensions and Weight Data
Wheel base
Overall height (to the top of the
ROPS)
Overall width (at the tires)
Minimum ground clearance
Turning radius (2-wheel
steering)
Turning radius (4-wheel
steering)
Weight (without attachments)
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
21
Figure 18
2. Battery Off position
149.8 cm (59.0 in)
243.8 cm (96.0 in)
170.2 cm (67.0 in)
30.5 cm (12.0 in)
464.8 cm (183 in)
294.6 cm (116 in)
2,494 kg (5,500 lb)
Advertisement
Table of Contents
