Drive System Maintenance; Adjusting The Tracking - Toro 74253 Operator's Manual

60in or 72in turbo force side discharge mower

Hide thumbs Also See for 74253:

Table of Contents

Figure 45

1. Fan-30 amp

2. Engine-10amp

3. Optional accessory

4. Ignition-30amp

5. Left side of machine

Drive System

Maintenance

The machine has a knob for adjusting the tracking

located under the seat.

Important: Adjust the handle neutral and hydraulic

pump neutral before adjusting the tracking. Refer

to Adjusting the Handle Neutral in Controls System

Maintenance , page 45 and Adjusting the Hydraulic

Pump Neutral in Hydraulic System Maintenance ,

page 46.

1. Push both control levers forward the same distance.

2. Check if the machine pulls to one side. If it does,

stop the machine and set the parking brake.

3. Unlatch the seat and tilt the seat forward to access

the tracking knob.

Note: Determine the left and right sides of the

machine from the normal operating position.

4. To make the machine go right, turn the knob towards

the rightside of the machine. Refer to Figure 46.

5. To make the machine go left, turn the knob towards

the leftside of the machine. Refer to Figure 46.

6. Repeat adjustment until the tracking is correct.

Table of Contents

74254 Z589 z master