Using The Drive-Wheel-Release Valves - Toro Z Master Professional 6000 Series Operator's Manual
Riding mower with 122cm turbo force side discharge mower
Hide thumbs
Also See for Z Master Professional 6000
Series:
- Operator's manual (80 pages) ,
- Setup instructions (16 pages) ,
- Operator's manual (84 pages)
Table of Contents
Advertisement
1. On position
Using the
Drive-Wheel-Release
Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel-release valves.
WARNING
The engine and hydraulic-drive units can
become very hot. Touching a hot engine or
hydraulic-drive units can cause severe burns.
Allow the engine and hydraulic-drive units
to cool completely before accessing the
drive-wheel-release valves.
The drive-wheel-release valves are located in the
back of each hydraulic-drive unit, under the seat.
Note:
Make sure that the release valves are in the
fully horizontal position when operating the machine
or severe damage to the hydraulic system can occur.
1.
Disengage the blade-control switch (PTO), turn
the ignition key to the O
levers to the N
EUTRAL
parking brake, and remove the key.
2.
Rotate the release-valve levers vertically to push
the machine
(Figure
Figure 37
2. Off position
position, move the
FF
-
position, engage the
LOCK
38).
Note:
This allows hydraulic fluid to bypass the
pump enabling the wheels to turn.
3.
Disengage the parking brake before pushing
the machine.
g008948
1. Vertical to push the
machine
4.
Rotate the release-valve levers horizontally to
run the machine
32
Figure 38
2. Horizontal to run the
machine
(Figure
38).
g008957
- Quick Links:
- Maintenance
Hide quick links:
Advertisement
Table of Contents
