Lifting Of Loads; Fig. 8: Attachment Of Loads On The Crane Hook; Fig. 9: Attachment Angle - ABB TPS52-H33 Operation Manual
Hide thumbs
Also See for TPS52-H33:
- Operation manual (114 pages) ,
- Operation manual (114 pages) ,
- Operation manual (108 pages)
Table of Contents
Advertisement
Operation Manual / TPS44-H.. - TPS52-H..
2 Safety / 2.9 Lifting of loads
2.9
Lifting of loads
WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
Loads must always be fastened to properly functional lifting gear with a
u
sufficient load limit.
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
u
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 8: Attachment of loads on the crane hook
Fig. 9: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
Before looping around the components of the turbocharger, let them cool down (max-
u
imum 80 °C).
Attach components of the turbocharger as described in the respective action steps.
u
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not loosen during use.
u
Use assembly devices only for the described applications.
u
Put down dismantled components of the turbocharger in such a way that they cannot tip
u
over.
© Copyright 2021 ABB. All rights reserved.
HZTL4037_EN
Rev.G
June 2021
Advertisement
Table of Contents
