1369/2017........................38 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
& breakfast and – other residential type environments; areas for communal use in blocks of flats or in – launderettes. Do not exceed the maximum load of 9 kg (refer to the •...
Page 5
ENGLISH 2.3 Water connection • The floor area on which the appliance is to be installed must be flat, stable, • Do not cause damage to the water heat resistant and clean. hoses. • Make sure that there is air circulation •...
• Visible LED radiation, do not look • Disconnect the appliance from the directly into the beam. mains electrical and water supplies. • The LED lamp is dedicated to drum • Cut off the mains electrical cable lighting. This lamp cannot be reused close to the appliance and dispose of for other lighting purposes.
Page 7
ENGLISH 5. Carefully put the appliance down on its rear side. 6. Put the front polystyrene packaging CAUTION! element on the floor under the Do not use alcohol, solvents appliance. or chemical products. 9. Make sure to identify the different sizes and the positions of the sound barriers.
Page 8
Attach the sound barriers at a room temperature. 13. Pull up the appliance in vertical position. We recommend that you keep the packaging and the transit bolts for any movement of the appliance. 3.2 Positioning and levelling 14. Remove the power supply cable and the drain hose from the hose holders.
Page 9
ENGLISH 4. Connect the water inlet hose to the A correct adjustment of the cold water tap with 3/4" thread. appliance level prevents the vibration, noise and the movement of the appliance when in operation. When the machine is installed on a plinth or if a washer dryer is stacked on the washing machine, use the accessories described in...
Page 10
You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide.
ENGLISH 6. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 4. PRODUCT DESCRIPTION 4.1 Special features steam programmes remove odours and reduce creases in dry fabrics so Your new washing machine meets all they need little ironing.
Internal light Inlet hose connection Rating plate Mains cable Drain pump filter Transit bolts Feet for levelling the appliance Hose support Drain hose 5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Extra rinse touch button (Extra Spülen)
Page 13
ENGLISH 5.2 Display Maximum load indicator. The icon flashes during laundry load esti- mation (refer to "PROSENSE load detection" paragraph). Maximum laundry indicator. It flashes when the laundry load exceeds the maximum declared load of the selected programme. Delay start indicator. Door locked indicator.
Temperature indicator. The indicator appears when a cold wash is set. Spin speed indicator. Rinse hold indicator. Extra silent indicator. Pre-wash indicator. Stain indicator. Extra rinse indicator. 6. DIAL AND BUTTONS 6.1 Ein /Aus 6.3 Temp. Pressing this button for a few seconds...
Page 15
ENGLISH The door stays locked. The drum Use this option to add a prewash turns regularly to reduce creasing. phase at 30 °C before the washing You must drain the water to unlock phase. the door. This option is recommended for Touch Start/Pause button: the heavily soiled laundry, especially if appliance performs the spinning...
Page 16
6.10 Skipping phase button A small laundry load helps to (Option) reach better results. By touching this button you can set: 6.8 Eco • Nur Spülen at first touch. The washing programme starts from the rinsing The Eco option reduces the energy phase by skipping the wash phase.
ENGLISH 7. PROGRAMMES 7.1 Programme Chart Washing programmes Programme Programme description Washing programmes White cotton and coloured cotton. Normal, heavy and light soil. Baumwolle Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, the programme Baumwolle at 60 °C and the programme Baumwolle at 40 °C with the option are respectively the «Standard 60°C cot- ton programme»...
Page 18
Programme Programme description White cotton items. This programme removes micro-organ- isms thanks to a washing phase with the temperature main- Anti-Allergie tained above 60°C for several minutes. This helps remove germs, bacteria, micro-organism and particles. An additional rinsing phase ensures a proper removal of detergent residues and pollens/allergenic items.
Page 19
ENGLISH Programme temperature, maximum spin speed and maximum load Programme Default temperature Reference spin Maximum load Temperature range speed Spin speed range 40 °C 1600 rpm 9 kg 95 °C - Cold 1600 rpm - 400 rpm Baumwolle 40 °C 1200 rpm 4 kg 60 °C - Cold...
ENGLISH 8. BEFORE FIRST USE 3. Pour 2 litres of water into the During installation or before detergent compartment marked by first use you may observe some water in the appliance. This action activates the drain system. This is a residual water left in 4.
This option increases slightly the programme duration. comes on/goes off above the indicator. To activate/deactivate this option touch the Temp. button and the U.Min. button 10. DAILY USE WARNING! CAUTION! Refer to Safety chapters. Make sure that no laundry stays between the seal and the door.
Page 23
ENGLISH After a washing cycle, if necessary, remove any detergent residue from the detergent dispenser. 10.4 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. With the flap in the position DOWN: •...
Page 24
Cancelling the delay start after The display shows the maximum declared load for the programme, the the countdown has started default temperature, the maximum spin speed, the washing phase indicators To cancel the delay start: (when available) and an indicative 1.
Page 25
ENGLISH 10.10 Interrupting a In this case, for 30 seconds, it is possible to pause the appliance and remove the programme and changing the exceeding garments. options Once removed the exceeding garments, When the programme is running, you touch the Start/Pause button to start the can change only some options: programme again.
Page 26
In the display the related door lock • The display shows the indicator , the indicator goes off. option indicator and the 2. Open the appliance door. If necessary, add or remove the items. door locked indicator . The 3.
ENGLISH If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. 11. HINTS AND TIPS 11.2 Stubborn stains WARNING! Refer to Safety chapters. For some stains, water and detergent is not sufficient.
11.4 Ecological hints 11.5 Water hardness • Set a programme without the If the water hardness in your area is high prewash phase to wash laundry with or moderate, we recommend that you normal soil. use a water softener for washing •...
Page 29
ENGLISH 12.5 Cleaning the drum Regularly examine the drum to prevent rust forming. For a complete cleaning: 1. Clean the drum with special products for stainless steel. Always follow the instructions that you find on the packaging of the product. 3.
Page 30
Clean the drain pump if: without removing. Let the water flow • The appliance does not drain the out. water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump.
Page 31
ENGLISH 12.8 Cleaning the inlet hose 10. Clean the filter under the water tap. and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1.
12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 33
ENGLISH • - No communication between WARNING! electronic elements of the appliance. Deactivate the appliance Switch it off and switch on again. before carrying out any check. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre.
Page 34
Problem Possible solution • Make sure that the couplings of the water hoses are tight and there is not water leakages. There is water on the • Make sure that the water inlet hose and the drain hose have floor.
ENGLISH 13.3 Emergency door opening To open the door, proceed as follows: 1. Press the Ein /Aus button to switch In case of power failure or functioning the appliance off. failure the appliance door remains 2. Disconnect the mains plug from the locked.
The tumble dryer can be stacked on the Read carefully the instructions supplied top of the washing machine only by with the accessory. using the correct stacking kit manufactured and approved by AEG.
17. PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION 1369/2017 Product Information Sheet Trade Mark Model L7FS86699, PNC 914550425 Rated capacity in kg Energy efficiency class A+++ Energy consumption in kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of...
Page 39
ENGLISH Programme time of the "standard 40°C cotton pro- gramme at partial load in minutes Duration of the left on mode in minutes Airborne acoustical noise emission in db(A) washing Airborne acoustical noise emission in db(A) spinning Built in appliance Y/N The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC .