hit counter script

Fujitsu Lifebook B112 User Manual page 125

Fujitsu lifebook b112: user guide
Hide thumbs Also See for Lifebook B112:
Table of Contents

Advertisement

2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screw of the memory upgrade
compartment. (See Figure 5-10.)
5. Remove the cover by lifting it by the notch in
the right edge and pulling it toward the left of
the notebook.
C A U T I O N
Memory upgrade modules can be
severely damaged by electro-static
discharge (ESD). Be sure you are
properly grounded when handling
and installing the module.
6. Remove the memory upgrade module from
its static guarded sleeve.
U s e r
I n s t a l l a b l e
F e a t u r e s
7. Align the connector edge of the memory
upgrade module with the connector slot in
the compartment. The notch on the module
should be on the right with the part side up
and the connector pointing towards the back
of the notebook and aligned with the notch
in the connector inside the compartment.
(See Figure 5-21.)
8. Insert the memory upgrade module at a
45° angle. (See Figure 5-21.) Press the con-
nector edge of the module firmly down and
into the connector.
9. Press the memory upgrade module down
into the compartment until it lodges under
the retaining clip. You will hear a click when
it is properly in place.
10.Replace the cover by sliding the tabs on the
left edge of the cover in the slots in the left
edge of the compartment and pushing the
cover gently down.
11.Replace the screws.
L i f e B o o k B 1 1 2 f r o m F u j i t s u
Memory upgrade modules are not something
you routinely remove from your notebook.
Once it is installed, leave it in place unless you
want to increase system memory capacity.
C A U T I O N
Before you install or remove a memory
upgrade module, save changes, close all
files and turn power off to your notebook.
(See Power Off on page 16.)
To Remove a Memory Upgrade Module
1. Perform steps 1 through 5 of To Install a
Memory Upgrade Module.
2. Pull clips sideways from each side of the
memory upgrade module.
3. While holding clips out, remove the module
from the slot by lifting it up and pulling
towards the front of your notebook.
4. Store the memory upgrade module in a static
guarded sleeve.
111

Advertisement

Table of Contents
loading

Table of Contents