Getting Started
Rear and center speakers
Rear
speaker
(R)
R
} ]
REAR SPEAKERS
Active woofer
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND OUT
CENTER terminal for use with Dolby Pro Logic
Surround Sound (see page 32).
Selecting the impedance
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
if nominal impedance of
your speaker is
Between 4 and 8 ohms
8 ohms or higher
12
Center
Receiver
speaker
L
} ]
CENTER SPEAKER
Receiver
Active woofer
MIX
INPUT
AUDIO
OUT
Set IMPEDANCE SELECTOR to
4
8
TV/VCR Hookups
Rear
speaker
(L)
Overview
} ]
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
MONITOR TV/DBS
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
Yellow
White (L)
Red (R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow
Hookups
The arrow ç indicates signal flow.
Monitor
If you are using your TV as a monitor, do not connect
anything to the TV/DBS IN jacks, unless you have a
Sony TV with TV OUT jacks (see page 25 for details).
Receiver
TV tuner or DBS (Digital Broadcasting Satellites) receiver
LD
VIDEO 2
VIDEO 1
Yellow
White (L)
Red (R)
Yellow
TV
MONITOR
OUT
CTRL S
INPUT
IN
VIDEO
OUT 1
Receiver
TV/DBS
TV/DBS
OUTPUT
VIDEO
VIDEO
IN
AUDIO
AUDIO
IN
L
L
R
R