Table of Contents
Advertisement
. . . . . . . . . . .2
Operating Instructions
Air Direction . . . . . . . . . . . . . . . . .4
Auxiliary Controls . . . . . . . . . . .5-9
Controls . . . . . . . . . . . . . . . . . . . . .3
To Remove the Room Cabinet . .4
Vent Control . . . . . . . . . . . . . . . . .4
Air Filters . . . . . . . . . . . . . . . . . . .11
Base Pan . . . . . . . . . . . . . . . . . . .10
Outdoor Coils . . . . . . . . . . . . . . .10
Room Cabinet and Case . . . . . . .10
Vent Filter . . . . . . . . . . . . . . . . . .10
Electrical Connection . . . . . .14-17
Installing the Zoneline . . . . .18, 19
Optional Drain Kit . . . . . . . . . . .20
Preparation . . . . . . . . . . . . . . . . .12
Replacing an Existing Unit? . . .13
. . . . .21, 22
Normal Operating Sounds . . . . .23
Consumer Support
Consumer Support . . . .Back Cover
Warranty . . . . . . . . . . . . . . . . . . .27
Write the model and serial
numbers here:
Model # ____________________
Serial # ____________________
Find these numbers on a label
behind the room cabinet on the
base pan.
ge.com
Installation Instructions
Español
For a Spanish version of this
manual, visit our Website at
ge.com.
Para consultar una version
en español de este manual
de instrucciones, visite nuestro
sitio de internet ge.com.
Française
For a French version of this
manual, visit our Website at
www.electromenagersge.ca.
Pour une version française de
ce manuel d'utilisation, veuillez
visiter notre site web à l'adresse
www.electromenagersge.ca.
TINSEA471JBRZ 49-7559-1
Owner's Manual and
Heat/Cool Model 2800
Heat Pump Model 3800
12-08 JR
Advertisement
Table of Contents
Related Manuals for GE Zoneline AZ28E09DAB
Summary of Contents for GE Zoneline AZ28E09DAB
-
Page 1: Table Of Contents
Website at ge.com. Para consultar una version en español de este manual de instrucciones, visite nuestro sitio de internet ge.com. Française For a French version of this manual, visit our Website at www.electromenagersge.ca. Pour une version française de ce manuel d'utilisation, veuillez visiter notre site web à... -
Page 2: Safety Instructions
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. SAFETY PRECAUTIONS ■... -
Page 3: Controls
3800 Series only When the outdoor temperature is lower than 20°F, heat is provided by the electric heater in the air conditioner instead of by the heat pump. About Your Heat Pump (3800 Series only) Heat pumps can save money by removing heat from the outside air—even when the outside... -
Page 4: Air Direction
Other features of your Zoneline. Ventilation Control The ventilation control lever is located at the upper left side of the Zoneline unit, behind the room cabinet. When set at the closed position, only the air inside the room is circulated and filtered. When set at the open position, some outdoor air will be drawn into the room. -
Page 5: Auxiliary Controls
When this switch is enabled (UP) , it allows the indoor fan to run continuously. When this switch is disabled (DOWN) , it allows the indoor fan to cycle on/off with the heat pump or heater operation. DOWN ge.com Dip Switches Access Cover HIGH DOWN COOL... - Page 6 Auxiliary controls on your Zoneline. Remote Thermostat—Class 2 When this switch is enabled (UP) , it allows the unit to operate with a Class 2 Remote Control Wall Thermostat. The unit controls are disabled. Load Shedding (Central Desk Control) This feature is active only if the unit is in CDC mode.
- Page 7 This feature automatically provides cooling without user interface. This helps to prevent an excessively hot room by turning the air conditioner ON at 85°F and OFF at 80°F. Heat Boost (AZ3800 only) When this switch is enabled (UP) and outdoor temperatures are between 20°F and 46°F, heat...
- Page 8 Auxiliary controls on your Zoneline. Auxiliary Controls—Terminal Connections The auxiliary controls are located behind the room cabinet beneath the access cover. Remove the room cabinet. See the To Remove the Room Cabinet section. Remove the screw from the access cover. To make wiring connections, insert the wires into the bottom of the terminals and tighten screws securely.
- Page 9 Damage to a wall thermostat or to the Zoneline electronics can result from improper connections. Special care must be used in connecting the wires. No line voltage connections should be made to any circuit. Isolate all wires in building from line voltage. ge.com...
-
Page 10: Care And Cleaning
If they are clogged with dirt or soot, they may be professionally steam cleaned, a service available through your GE service outlet. You will need to remove the unit to inspect the coils because the dirt buildup occurs on the inside. -
Page 11: Air Filters
Replacement filters are available from your salesperson, GE dealer, GE Service and Parts Center or authorized Customer Care ge.com 2 Air filters Do not operate the ®... -
Page 12: Installation Instructions
Installation Instructions Questions? Call 800.GE.CARES (800.432.2737) BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT – • instructions for local inspector’s use. IMPORTANT – • governing codes and ordinances. Note to Installer – • Be sure to leave these instructions with the owner. -
Page 13: Replacing An Existing Unit
REPLACING AN EXISTING UNIT? Use the correct wall case This unit is designed to be installed in a GE plastic or insulated metal wall case. This minimizes condensation from forming on the room side of the case. If the current wall case is not insulated, you can reduce... -
Page 14: Electrical Connection
Perpendicular 15 Amp. 20 Amp. 230/208 volt receptacle configuration. Branch Circuit and Proper GE Power Cord Unit Amperage Rating with LCDI Device *Not approved for use on 7000 BTU models. Installation Instructions Power cords may include an arc fault interruption or a leakage current detection interruption device. - Page 15 These models must be installed using the appropriate GE power supply kit for the branch circuit amperage and the electrical resistance heater wattage desired. Use the POWER CONNECTION CHART on page 17 to determine the correct kit required.
- Page 16 MAKE ELECTRICAL CONNECTION TO THE UNIT REMOVE JUNCTION BOX 1 Remove the junction box cover by removing the front two screws. 2 Remove the junction box by removing the top and bottom rear screws. Note how the tabs on the lower left side of the junction box serve to hold the side in place.
- Page 17 Installation Instructions POWER CONNECTION CHART 230/208 Volt Power Supply Kits with Current Leakage Wall Plug Detection Device Configuration RAK3153 Tandem RAK3203 Perpendicular RAK3303* Large Tandem 230/208 Volt Power Supply Kits @ 230/208 Volts RAK4157 2.55 KW/2.09 KW RAK4207 3.45 KW/2.82 KW RAK4307 5.00 KW/4.10 KW 265 Volt...
-
Page 18: Installing The Zoneline
• Install the exterior grille from the room side following instructions packed with the grille. Insulated Wall Case This unit is designed to be installed in a GE plastic or an insulated steel wall case. This minimizes condensation from forming on the room side of the case. - Page 19 NOTE: There are several extra holes in the unit side flanges for installation in wall cases other than GE. To avoid damaging the flange insulation, the installer should use an awl or other sharp tool to puncture the insulation in the appropriate holes before installing the attachment screws.
-
Page 20: Optional Drain Kit
OPTIONAL—DRAIN KIT INSTALLATION Dry Air 25 Series models are designed to improve dehumidification by 25%. Since more moisture will be removed from the air, there is a greater possibility that water will drip from the wall case than with a standard unit. To prevent this water from dripping onto external building walls, we recommend the use of RAD10 Drain Kit. -
Page 21: Troubleshooting Tips
• Outdoor grille must have a minimum of 65% free area. Non-GE grilles may be too restrictive for proper performance. Consult your salesperson for assistance. • Turn the control to a lower or higher setting. - Page 22 Before you call for service… Problem Possible Causes The air is not always The heat pump is not cool or hot during producing hot air. operation The fan switches may be set at continuous fan. The air does not feel The heat pump alone warm enough during produces air that feels...
-
Page 23: Normal Operating Sounds
Things that are normal. ge.com Normal Operating Sounds You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency. - Page 24 Notes.
- Page 25 Notes. ge.com...
- Page 26 Notes.
-
Page 27: Warranty
This warranty is extended to the original purchaser and any succeeding owner for products purchased for use within the USA and Canada. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service. -
Page 28: Consumer Support
Caution must be exercised, since improper servicing may cause unsafe operation. Contact Us If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations Register Your Appliance Register your new appliance on-line—at your convenience! Timely product registration will allow for...