Table of Contents
Advertisement
9 Coin meter operation
In coin operated machines prices for programs and other operational parameters must be programmed during ma-
chine setup.
Prices can be programmed as Euros or as the number of coins or tokens required to start and to add additional dry-
ing time.
There are four drying programs High, Medium, Low, and No Heat. These four programs can be programmed for dif-
ferent prices and times. When the machine is in standby mode (i.e. before the drying program begins), the selected
drying program may be changed. Once a drying program has started, the program may be changed only if all the pro-
grams High, Medium, Low and No Heat have identical settings for price, drying time, and time added for each addi-
tional coin or press.
After the initial drying time has been purchased for a selected program, additional drying time may be added by in-
serting more coins. The amount of extra time per coin inserted for the selected program can be programmed in the
service registers. Additional drying time up to the maximum allowed may be purchased.
9.1 Price Programming & Drying Time Program Setup
Amount to Start (ATS) service registers 040-043 define the price that must be paid before a selected program may
be started.
The ATS price is displayed when the machine is idle. As each coin is deposited the display will count down by the
"Coin 1 Value" or "Coin 2 Value" as the coin pulses are received. The following instructions show how to set up prices
for drying programs.
1. Unlock and separate the PCB assembly from the control panel seat.
2. Press the reset button for 2 seconds， then release the finger to enter service mode.
When you enter the service mode successfully by this method,the PCB will display 8888
A
A
reset button
3.
Press the start button, "SE" shall appear in the display confirming access to the service registers.
4.
Use the "Low" and "No Heat" buttons to navigate to the desired register.
5.
Go to register 40, High heat and press Start to enter. The current price will be shown in the display, blinking.
6.
Use the three program selection buttons; Medium, Low, and No Heat to change each of the three digits in the
price display. Each button increments a corresponding digit, left to right, in the price. Each digit rolls over from 9
to 0 without affecting the other digits. Once the desired price has been set in the register, press the Start button
to save the value and exit the register.
7.
If registers 041, 042, and 043 = "0.00" the values of these registers will be set to the same value as register
"040". If different pricing is desired, program each register separately repeating steps 4-5.
8.
Press the Service Switch in the vault to exit service mode.
9.
Check the newly entered prices by selecting each program.
Register 030 (Coin / Token Mode) determines how prices are displayed by the machine. When set to "00" (default),
prices are set and displayed with a decimal (e.g. "3.00"). When set to "01", the decimal point is turned off, and prices
are set and displayed as "number of coins or tokens" required (e.g. "12"). In either case, the value of each coin drop
is stored in Register 031 "Coin Value 1" and Register 032 "Coin Value 2" and determine how much the remaining
price will be reduced each time a coin is deposited. The coin-value registers can be adjusted to accommodate any
currency.
Installation manual
35
fig.W01633
Hide quick links:
Advertisement
Table of Contents
