Table of Contents
Advertisement
T
P
S
RANSMIT
OWER
AVER
The purpose of the Transmit Power Saver is to prevent you
from transmitting continuously for a long time. This function is
useful, for example, when you accidentally keep the PTT
switch pressed.
If you continuously transmit for 3 minutes, the transceiver will
stop transmitting and a tone will sound. To stop the tone,
release the PTT switch. You can press the PTT switch again
to resume transmitting. The 3 minute timer cannot be
adjusted.
This transceiver is also equipped with a visual
warning, 30 seconds before the Transmit
Power Saver time expires, and a pre-alert
tone which sounds 10 seconds before the
time expires. This will allow you to finish your
message before the transceiver automatically
stops transmitting. Thirty seconds before the
time expires, the number 30 will appear and
blink on the display in place of your Group
Mode number. Ten seconds before the time
expires, a tone will sound.
B
S
ATTERY
AVER
This transceiver has been designed to give you the most out
of your battery power. The battery saver decreases the
amount of power used when a signal is not being received
and no operations are being performed.
While using the transceiver, the battery saver will
automatically switch ON after 5 seconds have elapsed with no
operations or received calls. Operating the transceiver or
receiving a call will switch the feature OFF until 5 seconds of
non-operation occurs again.
21
Advertisement
Table of Contents
