Advertisement
Quick Links
Thank you for purchasing the Singalong Kit to accompany the McRoboFace "emoticon". This kit will
allow you to build the breadboard to work with Robin Newman's project from
Note that we have used different components from the project shown in the link above, but the
circuit is the same and easier to assemble.
Step 1 – Check you Have All Components
400-point Breadboard
•
1m Audio lead (white)
•
Audio splitter lead (black)
•
Strip of 10 dupont cables, 30cm
•
Red jumper wire
•
Black jumper wire
•
Audio cable to breadboard connector PCBA
•
12mm Tact switch
•
10K breadboard-friendly trim pot
•
10K resistor (Bands are Brown, Black, Orange)
•
2 x 47uF capacitors
•
Step 2 – Plug in the Audio Connector PCBA
Singalong Kit Assembly
this link
Advertisement
Related Manuals for 4tronix Singalong Kit
Summary of Contents for 4tronix Singalong Kit
- Page 1 Singalong Kit Assembly Thank you for purchasing the Singalong Kit to accompany the McRoboFace “emoticon”. This kit will allow you to build the breadboard to work with Robin Newman’s project from this link Note that we have used different components from the project shown in the link above, but the circuit is the same and easier to assemble.
- Page 2 Singalong Kit Assembly 1. Check you have the breadboard oriented correctly with row 1 at the left as shown in photo 2. Plug in the audio connector to d4, d5, d6 and f4, f5, f6 Step 3 – Make a 1cm Jumper Wire Cut a 24mm piece of Black wire •...
- Page 3 Singalong Kit Assembly Step 5 – Form First Capacitor It is important to get the correct polarity for these capacitors. For this one, leave the • negative lead straight and bend the positive lead The positive lead should be 0.3” (8mm) from the negative lead •...
- Page 4 Singalong Kit Assembly Step 7 – Form Second Capacitor So that the two capacitors fit together, we bend the negative lead on this one and leave the • positive lead straight The separation of the leads should be 0.2” (5mm) •...
- Page 5 Singalong Kit Assembly Step 9 – Fit 10K trimPot Orient the trimpot as shown and fit the centre pin into g13 (photo shows h13, but use g13) • The other two legs fit in h12 and h14 • Step 10 – Add Power and Ground Links to Trimpot Cut, strip and bend jumper wires as before •...
- Page 6 Singalong Kit Assembly Step 11 – Form the 10K Resistor Cut and bend resistor leads as shown above • Leads should be 0.5” (12.5mm) apart and 7mm long • Step 12 – Fit the Resistor Fit the resistor in holes f8 and f13 •...
- Page 7 Singalong Kit Assembly Step 13 – Fit the Tact Switch and connect to Ground Take care not to bend the pins on the switch • Push into holes d20, d22, g20, g22 • Cut, strip and bend another piece of black jumper wire •...
- Page 8 Singalong Kit Assembly Step 15 – Wire in McRoboFace Split the strip of 10 jumper wires as follows: • o Brown, Red, Orange o Black, White, Grey o Violet, Blue, Green You should have a single Yellow wire left (this is not needed) •...
- Page 9 Singalong Kit Assembly Step 16 – Wire in Audio Output and Switch Output Use the Green, Blue and Violet wires to connect the Audio: • o Green to breadboard Negative rail o Blue to breadboard Positive rail o Brown to hole j8 For the switch, use the Black, White and Grey wires: •...