Related Manuals for LG 42LM3410.ATR
Summary of Contents for LG 42LM3410.ATR
- Page 1 OWNER’S MANUAL LED LCD TV / LCD TV Please read this manual carefully before operating your set and retain it for future reference. LS34** LM34** CS46** CS47** P/NO : MFL67360812 (1202-REV01) www.lg.com...
- Page 3 Isolator Usage (Safety Caution) 1. Always use isolator with RF signal port (In wall RF port or in set RF Port). 2. Isolator will protect if there is any voltage difference between GND of power Board and GND of Antenna Signal, the Antenna contact might be heated and excessive heat might cause an accident, therefore Isolator installation is highly recommended.
-
Page 4: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS LICENSES OPEN SOURCE SOFTWARE NOTICE SAFETY INSTRUCTIONS - Viewing 3D Imaging (Only 3D models) INSTALLATION PROCEDURE ASSEMBLING AND PREPARING Unpacking Separate purchase Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the stand Mounting on a table Mounting on a wall... -
Page 5: Licenses
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping and handling) upon email request to opensource@lge.com. -
Page 6: Safety Instructions
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS Please read these safety precautions carefully before using the product. WARNING y Do not place the TV and remote control in the following environments: - A location exposed to direct sunlight - An area with high humidity such as a bathroom - Near any heat source such as stoves and other devices that produce heat - Near kitchen counters or humidifiers where they can easily be exposed to steam or oil... - Page 7 SAFETY INSTRUCTIONS y Do not plug too many electrical devices into a single multiple electrical outlet. Otherwise, this may result in fire due to over-heating. y Do not drop the product or let it fall over when connecting external devices. Otherwise, this may result in injury or damage to the product.
- Page 8 SAFETY INSTRUCTIONS y Do not disassemble, repair or modify the product at your own discretion. Fire or electric shock accident can occur. Contact the service center for check, calibration or repair. y If any of the following occur, unplug the product immediately and contact your local service centre.
- Page 9 SAFETY INSTRUCTIONS CAUTION y Install the product where no radio wave occurs. y There should be enough distance between an outside antenna and power lines to keep the former from touching the latter even when the antenna falls. This may cause an electric shock. y Do not install the product on places such as unstable shelves or inclined surfaces.
- Page 10 SAFETY INSTRUCTIONS y Do not turn the product On/Off by plugging-in or unplugging the power plug to the wall outlet. (Do not use the power plug for switch.) It may cause mechanical failure or could give an electric shock. y Please follow the installation instructions below to prevent the product from overheating.
- Page 11 SAFETY INSTRUCTIONS y When moving or unpacking the product, work in pairs because the product is heavy. Otherwise, this may result in injury. y Contact the service center once a year to clean the internal parts of the product. Accumulated dust can cause mechanical failure. y Refer all servicing to qualified service personnel.
-
Page 12: Viewing 3D Imaging (Only 3D Models)
SAFETY INSTRUCTIONS Viewing 3D Imaging (Only 3D models) WARNING Viewing Environment y Viewing Time - When watching 3D contents, take 5 - 15 minute breaks every hour. Viewing 3D contents for a long period of time may cause headache, dizziness, fatigue or eye strain. Those that have a photosensitive seizure or chronic illness y Some users may experience a seizure or other abnormal symptoms when they are exposed to a flashing light or particular pattern from 3D contents. - Page 13 Cautions when using the 3D glasses y Make sure to use LG 3D glasses. Otherwise, you may not be able to view 3D videos properly. y Do not use 3D glasses instead of your normal glasses, sunglasses or protective goggles.
-
Page 14: Installation Procedure
INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING NOTE y Image shown may differ from your TV. y Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. y The available menus and options may differ from the input source or product model that you are using. - Page 15 ASSEMBLING AND PREPARING Remote control and batteries (AAA) (See p. 27, 28) Owner’s manual Screw for assembly Polishing cloth 2EA, P4 x 20 (Depending on model) (Only 22CS46**, Use this to remove dust 22CS47**) from the cabinet. (See p. 18) Screw for assembly Screw for fixing 8EA, M4 x 20...
- Page 16 ASSEMBLING AND PREPARING Stand Body / Stand Base (Only 22CS46**, 22CS47**) (See p. 18) Stand Body / Stand Base (Only 26CS46**, 26CS47**) (See p. 18) Stand Body / Stand Base (Only 32/42CS46**, 32/42CS47**, 32/42LS34**, 32/42LM34**) (See p. 19)
-
Page 17: Separate Purchase
ASSEMBLING AND PREPARING Separate purchase Separate purchase items can be changed or modified for quality improvement without any notification. Contact your dealer to buying these items. These devices only work with certain models. AG-F3** Cinema 3D Glasses The model name or design may be changed depending on the upgrade of product functions, manufacturer’s... -
Page 18: Parts And Buttons
ASSEMBLING AND PREPARING Parts and buttons Screen Remote control and intelligent sensors Power indicator Speakers Touch buttons SETTINGS INPUT Power/Standby indicator (Can be adjusted using the Power indicator in the OPTiON menu.) Touch Button Description Scrolls through the saved programmes. Adjusts the volume level. -
Page 19: Lifting And Moving The Tv
ASSEMBLING AND PREPARING Lifting and moving the TV y When transporting a large TV, there should be at least 2 people. y When transporting the TV by hand, hold the TV Please note the following advice to prevent the as shown in the following illustration. TV from being scratched or damaged and for safe transportation regardless of its type and size. -
Page 20: Setting Up The Tv
ASSEMBLING AND PREPARING Setting up the TV Attaching the stand Image shown may differ from your TV. 26CS46**, 26CS47** 22CS46**, 22CS47** M4 x 20 Stand Body Stand Base Stand Body P4 x 20 M4 x 20 Stand Base... -
Page 21: Mounting On A Table
ASSEMBLING AND PREPARING Image shown may differ from your TV. 32/42CS46**, 32/42CS47**, 32/42LS34**, CAUTION 32/42LM34** y When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. M4 x 20 y Tighten the screws firmly to prevent the TV Stand Body... - Page 22 ASSEMBLING AND PREPARING Securing the TV to a wall Adjusting the angle of the TV to suit view (This feature is not available for all models.) (Only 32/42CS46**, 32/42CS47**, 32/42LS34**, 32/42LM34**) Swivel 20 degrees to the left or right and adjust the angle of the TV to suit your view.
-
Page 23: Mounting On A Wall
Kensington security system or LG recommends that wall mounting be performed visit http://www.kensington.com. by a qualified professional installer. Connect the Kensington security system cable between the TV and a table. -
Page 24: Tidying Cables
1 Gather and bind the cables with the cable wall, it may fall and result in severe injury. management. Use an authorized LG wall mount and 2 Fix the cable management firmly to the TV. contact the local dealer or qualified personnel. -
Page 25: Making Connections
MAKING CONNECTIONS MAKING Antenna connection CONNECTIONS Connect the TV to a wall antenna socket with an RF cable (75 Ω). y This section on MAKING CONNECTIONS mainly uses diagrams for the CS46** models. Connect various external devices to the TV and switch input modes to select an external device. -
Page 26: Hdmi Connection
MAKING CONNECTIONS HDMI connection Component connection Transmits the digital video and audio signals from Transmits analog video and audio signals from an an external device to the TV. Connect the external external device to the TV. Connect the external device and the TV with the HDMI cable as shown. device and the TV with a component cable as shown. -
Page 27: Composite Connection
MAKING CONNECTIONS Composite connection USB connection Connect a USB storage device such as a USB Transmits analog video and audio signals from an flash memory, external hard drive, or a USB external device to the TV. Connect the external memory card reader to the TV and access the My device and the TV with the composite cable as media menu to use various multimedia files. -
Page 28: Headphone Connection
MAKING CONNECTIONS Headphone connection (Only 22/26/32/42CS47**) (*Not Provided) Transmits the headphone signal from the TV to an external device. Connect the external device and the TV with the headphone as shown. NOTE y AUDIO menu items are disabled when connecting a headphone. y Headphone impedance: 16 Ω... -
Page 29: Remote Control
REMOTE CONTROL REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching ends to the label inside the compartment, and close the battery cover. - Page 30 REMOTE CONTROL (Only 32/42LM34**) Used for viewing 3D video. TV/RAD Selects Radio, TV and DTV programme. Shows programme guide. GUIDE INFO RATIO Views the information of the current programme and screen. Resizes an image. Changes the input source; Turns the TV on. Accesses the saved programme list.
-
Page 31: Using The User Guide
USING THE USER GUIDE USING THE USER GUIDE User Guide allows you to more easily access the detailed TV information. 1 Press SETTINGS to access the main menus. User Guide OPTION > To set language 2 Press the RED button to access the Customer SETTING ... -
Page 32: Maintenance
MAINTENANCE / TROUBLESHOOTING MAINTENANCE Cleaning your TV Clean your TV regularly to keep the best performance and to extend the product lifespan. CAUTION y Make sure to turn the power off and disconnect the power cord and all other cables first. y When the TV is left unattended and unused for a long time, disconnect the power cord from the wall outlet to prevent possible damage from lightning or power surges. -
Page 33: Environmental Information
TROUBLESHOOTING / ENVIROMENTAL INFORMATION ENVIRONMENTAL INFORMATION... -
Page 34: Specifications
SPECIFICATIONS SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. For the power supply and power consumption, refer to the label attached to the product. 22CS46** 26CS46** 32CS46** 22CS460-TA 26CS460-TA 32CS460-TA MODELS 22CS460Y-TA 26CS460Y-TA 32CS460Y-TA 22CS461-TB 26CS461-TB... - Page 35 SPECIFICATIONS Environment Operating Temperature 0 °C to 40 °C condition Operating Humidity Less than 80 % Storage Temperature -20 °C to 60 °C Storage Humidity Less than 85 % Digital TV Analogue TV New Zealand, Television System DVB-T PAL/SECAM-B/G/D/K, PAL-I Singapore BG : VHF/UHF 1 to 69, CATV 01 to 47 Programme...
- Page 36 SPECIFICATIONS HDMI-DTV supported mode Component port connecting information Component ports on the TV Y Resolution Horizontal Vertical Frequency Frequency (kHz) (Hz) Video output ports on DVD player 720x480 31.469 59.94 31.5 720x576 31.25 1280x720 37.5 44.96 59.94 Component Signal 480i/576i 1920x1080 33.72 59.94...
- Page 38 LGEIL,22(1-A)/21(2-B)/2, RIICO Heavy Industrial area, Jodhpur - 342003 2742384,392, 5120030 (Fax) Karnal LG ELECTRONICS INDIA PVT LTD,Super Tyre Building, Near New Anaj Mandi, Opp , 2219201, 2219202 (Fax) New World Restauarnt, G.T road Karnal, Haryana Lucknow LGEIL, B- 537,Hari Kunj, Keshav Nagar, Sitapur Road Lukhnow -226020...
- Page 40 (Only DTV) Record the model number and serial number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service. MODEL Trade Mark of the DVB Digital Video Broadcasting Project (1991 to 1996) SERIAL...