Table of Contents
Advertisement
3 Rigging And Caster Setting
_________________________________________________________________________________________________________
XY-101/122/152:
Using the two socket head bolts(B), align the mounting holes in
the inner yoke of the Vertical Flying Cradle(A) with the mounting
points on the top of the enclosure. (Fig.3-2-1-C)
WARNING: The Vertical Flying Cradles should be installed to the
XY-122/152 enclosure in a specific orientation. Please see Fig.3-
2-1-D to install the Vertical Flying Cradle to the enclosure in the
correct orientation.
FRONT
XY-122
Ensure that both the Flat Washer(D) and the Spring Washer(C)
are used - the Flat Washer(D) should be in contact with the
cradle. Tighten the bolts over 15N·m torque (Only XY-101: 7N·m
torque). (Fig.3-2-1-C)
(3)
Once the desired angle of the loudspeaker is set, tighten the
knobs/levers on the cradle to lock the position in place.
(Fig.3-2-1-E)
(4)
The hole on the outer yoke of the Vertical Flying Cradle (A) can
be used to install the speaker to the ceiling. (Fig.3-2-1-E)
(5)
Remove the pre-inserted mounting screw on following point of
the enclosure.
XY-81/101/122:
The front part or rear part of the top point on the enclosure
XY-152:
The upper rear part on the enclosure
(6)
Ensure the commercially-available eyebolt is secured to the
mounting point to suspend it with wire as a secondary safety
feature. (Fig.3-2-1-F)
http://pioneerproaudio.com/
FRONT
XY-152
Fig.3-2-1-D
Only XY-152
Fig.3-2-1-C
1 x φ13
Fig.3-2-1-E
Commercially-
available
eyebolt
Only XY-152
Commercially-
available
eyebolt
Fig.3-2-1-F
©2018 Pioneer DJ CORPORATION
(B
(C)
(D)
Page 23 / 92
Advertisement
Table of Contents
