Installing The Low-Pressure Stage - ABB Power2 845-M46 Operation Manual
Hide thumbs
Also See for Power2 845-M46:
- Operation manual (106 pages) ,
- Operation manual (106 pages) ,
- Operation manual (106 pages)
Table of Contents
Advertisement
Operation Manual / Power2 845-M / 4.1 Low-pressure stage
2 Removal and installation / 2.3 Installing the low-pressure stage
2.3
Installing the low-pressure stage
Fig. 2: Suspension of complete low-pressure stage
Attach one lifting gear to each of the two bearing casing suspension points.
u
Check that the orifices specified for the low-pressure stage have been installed in both oil
u
supply lines.
Check that the gaskets of the oil supply and the oil drain have been correctly installed in
u
the bracket.
Align the low-pressure stage on the engine.
u
Tighten the fixing elements on the foot according to the instructions of the engineb-
u
uilder.
Attach all gas, air, cleaning and oil pipes according to the instructions of the engineb-
u
uilder.
Connect the cable connector to the speed sensor.
u
Fit insulation according to the instructions of the enginebuilder.
u
© Copyright 2018 ABB. All rights reserved.
HZTL4068_EN
Revision A
March 2018
Advertisement
Chapters
Table of Contents
