Related Manuals for Toro LX466
Summary of Contents for Toro LX466
- Page 1 Form No. 3360-320 Rev A LX466 Lawn Tractor Model No. 13AT61RH544 769-03027B (2/19/08) Register your product at www.Toro.com...
-
Page 2: Table Of Contents
A sample model plate is also illustrated below. You can locate the model plate by looking at the underside of the tractor’s seat. This information will be necessary to use the manufacturer’s web site and/or help from a Toro Service Dealer. -
Page 3: Important Safe Operation Practices
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. - Page 4 25. Disengage the PTO and all attachment clutches, 6. Keep all movement on the slopes slow and gradual. depress the brake pedal completely and shift into Do not make sudden changes in speed or direction. neutral before attempting to start engine. Rapid engagement or braking could cause the front 26.
- Page 5 into reverse. The “Reverse Caution Mode” fuel tank or container opening at all times should not be used when children or others until fueling is complete. Do not use a nozzle are around. lock-open device. g. Keep children away from hot or running e.
- Page 6 equipment is in safe working condition. 12. For safety protection, frequently check components 8. Never tamper with the safety interlock system or and replace immediately with original equipment other safety devices. Check their proper operation manufacturer’s (O.E.M.) parts only. “Use of parts regularly.
-
Page 7: Safety Labels
SECTION 2: SAFETY AND INSTRUCTIONAL LABELS Safety and instructional labels found on your lawn tractor are illustratefd below. Always follow their instructions and heed their warnings. If you discover a safety label is scratched, damaged or missing, order a replacement immediately. - Page 8 Part No. 112-3702 Part No. 112-1269 MARCHE ARRÊT Part No. 112-3704 Part No. 112-0533 S30296 Part No. 112-1267 S30544 MAX 20 % Part No. 112-3709 Part No. 112-5962...
-
Page 9: Slope Gauge
SECTION 3: SLOPE GAUGE Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn tractor on such slopes. -
Page 10: Tractor Set-Up
SECTION 4: TRACTOR SET-UP Attaching The Steering Wheel • Remove the black plastic cover, if present, from the negative battery terminal and attach the negative 1. If the steering wheel for your tractor did not come cable (heavy black wire) to the negative battery attached, the hardware for attaching it has been terminal (–) with the bolt and hex nut. - Page 11 Attaching The Seat 2. Place the PTO lever cap over the hex nut and push downward until it “clicks” into place. If the seat for your tractor did not come attached, follow the instructions below to attach it. Shipping Brace Removal 1.
- Page 12 Setting the Gauge Wheels • If the gauge wheels have excessive clearance with the surface below, lower the wheels to the index Tools Required hole that provides the approximate 1/2" clearance (2) 9/16" wrenches as described above. Refer to Leveling the Deck on page 20 of this manual for Select the height position of the cutting deck by placing more detailed instructions regarding various deck the deck lift lever in any of the six different cutting height...
-
Page 13: Know Your Lawn Tractor
SECTION 5: KNOW YOUR LAWN TRACTOR NOTE: Steering Wheel not shown for clarity. Figure 8 A Systems Indicator Monitor/Hour Meter G Throttle / Choke Control B PTO (Blade Engage) Lever H Ignition Switch Module C Parking Brake Lever I Brake Pedal D Choke Control J Drive Pedal E Cruise Control Lever... - Page 14 Throttle Control Ignition Switch Module The throttle control is located on WARNING: Never leave a running machine the right side of the tractor’s dash unattended. Always disengage the PTO, panel. This lever controls the move the shift lever into Neutral, set the speed of the engine.
- Page 15 Refer to Always set the parking IMPORTANT: the MAINTAINING YOUR LAWN TRACTOR section of this brake when leaving the tractor unattended. manual for the proper battery charging procedure or have the charging system checked by an authorized Toro service dealer.
-
Page 16: Operating Your Lawn Mower
If the interlock system should ever malfunction, do not are around. Stop the tractor immediately if operate the tractor. Contact an authorized Toro service someone enters the area. dealer. To use the REVERSE CAUTION MODE: •... - Page 17 Starting the Engine Driving The Tractor WARNING: WARNING: Do not operate the tractor if the Avoid sudden starts, ex- interlock system is malfunctioning. This cessive speed and sudden stops. system was designed for your safety and protection. WARNING: Do not leave the seat of the tractor without first placing the PTO/Blade NOTE: Service the engine with gasoline and oil as...
- Page 18 Driving On Slopes Engaging the Parking Brake Refer to the SLOPE GAUGE on page 9 to help determine To engage the parking brake: slopes where you may operate the tractor safely. 1. Fully press the brake pedal and hold it while gently pushing the parking brake lever downward.
- Page 19 Using the Deck Lift Lever Moving the Tractor Manually To raise the cutting deck, move the deck lift lever to the Your tractor’s transmission is equipped with a left, then place it in the notch best suited for your hydrostatic relief valve for occasions when it is application.
-
Page 20: Making Adjustments
SECTION 7: MAKING ADJUSTMENTS WARNING: Never attempt to make any adjustments while the engine is running, Seat Adjustment To adjust the position of the seat, loosen the two knobs on the bottom of the seat. See Figure 3. Slide the seat forward or rearward as desired. -
Page 21: Maintaining Your Lawn Tractor
Steering Adjustment If the tractor turns tighter in one direction than the other, or if the ball joints are being replaced due to damage or wear, the steering drag links may need to be adjusted. Adjust the drag links so that equal lengths are threaded into the ball joint on the left side and the ball joint on the right side: Hex Nut... -
Page 22: Service
Lubrication • Pinch the tabs on the oil drain valve, then pull outward to begin draining oil. See Figure 17 . • After the oil has finished draining, push the oil drain WARNING: Before lubricating, repairing, or valve back in, until the tabs click into place. Re-cap inspecting, always disengage PTO, move the end of the oil drain valve to keep debris from shift lever into neutral position, set parking... - Page 23 WARNING: It is important that each cutting blade edge be ground Before lubricating, repairing, or equally to maintain proper blade balance. A poorly inspecting, always disengage PTO, move balanced blade will cause excessive vibration and may shift lever into neutral position, set parking cause damage to the tractor and result in personal brake, stop engine and remove key to prevent injury.
- Page 24 Jump Starting bottom notch on the right fender. 3. Remove the belt keeper rod from around the WARNING: Never jump start a damaged or engine pulley by removing the self-tapping screw. frozen battery (a battery can be identified as 4. Remove the deck belt from around the tractor’s frozen if its sides are bulged out, it’s frosty and engine pulley (or electric PTO clutch, if so it feels very solid).
- Page 25 NOTE: All belts on your tractor are subject to wear and should Models with a 46-inch deck and manual PTO be replaced if any signs of wear are present. are equipped with a short cable which controls the deck spindle brake. It is necessary to unhook this cable in The V-belts found on your tractor are IMPORTANT: order to fully remove the cutting deck from the tractor.
-
Page 26: Off-Season Storage
SECTION 10: OFF-SEASON STORAGE WARNING: • Refer to the engine manual for correct engine Never store the machine or storage instructions. engine must fuel container indoors where there is an open completely drained of fuel to prevent gum deposits flame, spark or pilot light such as on water from forming on essential carburetor parts, fuel heater, furnace, clothes dryer or other gas lines and fuel tanks... -
Page 27: Maintenance Chart
SECTION 11: MAINTENANCE CHART Before Every Every Every Every Every Prior Each Use 10 Hours 25 Hours 50 Hours 200 Hours Season to Storing Check Safety Interlock System Clean Hood/Dash Louvers Check Engine Oil Level Replace Air Filter Element Change Engine Oil & Filter Clean Battery Terminals Lube Front Axles and Rims Clean Engine Cooling Fins... -
Page 28: Troubleshooting
SECTION 12: TROUBLESHOOTING Trouble Possible Cause(s) Corrective Action Engine fails to start PTO engaged. Place PTO knob (or lever) in disengaged (OFF) position. Parking brake not engaged. Engage parking brake. Spark plug wire(s) disconnected. Connect wire(s) to spark plug(s). Throttle/choke control not in correct Move Throttle/Choke Control into CHOKE position. -
Page 29: Specifications
43 in. (109.2 cm) Ground Clearance 4.5 in. (11.4 cm) Turning Radius 18 in. (46 cm) Weight (approximate) 498 lb. (225.9 kg) * Toro reserves the right to change product specifications, design, and standard equipment without notice and without incurring obligation. - Page 30 ELECTRIC SCHEMATIC...
-
Page 31: Warranty Information
Routine maintenance items such as lubricants, filters, blade sharpening, tune-ups, brake adjustments, clutch The limited warranty set forth below is given by The Toro Company adjustments, deck adjustments, and normal deterioration of (“Toro”) and The Toro Warranty Company, pursuant to an the exterior finish due to use or exposure. - Page 32 notes . . .
- Page 33 notes . . .