Table of Contents
Advertisement
Configuring Plug and Play with the SETUP program
The SETUP program can be used to select the level of support provided by the BIOS for
Plug and Play-compatible accessory boards:
1.
Turn on the PC and press [F2] when <Setup=F2> appears.
2
Highlight the Plug and Play Device Management line and use [F7] or F8 to select None, Boot Only,
or Full.
If None is selected, use the ISA Configuration Utility (ICU) to con figure all accessory boards.
If Boot Only is selected, ISA Plug and Play accessory boards which have the ability to boot
(start) your PC will be configured by the BIOS. Use the ICU to configure all other accessory
boards.
If Full is selected, all ISA Plug and Play accessories will be configured by the BIOS. However,
if you install a non-Plug and Play accessory board, use the ICU to determine a conflict-free
setting for the board.
3
Press F3 to save your selection and exit from the SETUP program.
NOTE
For operating systems that have integrated support for Plug and Play (such as
Windows 95), None must be selected because the operating system won't expect
the BIOS to configure Plug and Play devices.
HP Vectra XM 5/xx Series PC Familiarization Guide
46
2 PC Hardware Structure
Advertisement
Table of Contents
