Update - Tabor Electronics Lucid Series User Manual

Rf analog signal generator benchtop

Hide thumbs Also See for Lucid Series:

Table of Contents

• DHCP – Dynamic Host Configuration Protocol.

Fixed – Define a static IP Address. Verify that the PC running Lucid software is on the same

⧫

network (default).

Dynamic – Get an IP address from the DHCP server. The IP Address, Port and Subnet Mask

⧫

fields are not accessible.

• IP Address – Define a static IP address.

• Subnet Mask – Verify that the PC running Lucid software is on the same network.

• MAC – The device MAC address.

• Host – The device computer name.

• Port – Define the SCPI port for communication. User should use a free port in the range 1 to 65535.

• BACK – Click the button to return to the System dialog box.

3.6.5

Update

Select on the device display the System tab, and then click the Update button to update the device

software. Refer to "Lucid Control Panel User Manual" section "Appendix FPGA Firmware Update" for

how to update the FPGA firmware.

Device SW Update Sequence

1. Prepare on a PC an USB flash memory that is formatted to exFAT file system.

2. Download the "Lucid Benchtop FW - x.y.z.zip" file from the Tabor Electronics website at

http://www.taborelec.com/downloads

3. Unzip the file. The new directory x.y.z contains two files:

a. benchtop_fw.tar.gz

b. Manifest

4. Insert the flash memory in a free USB connector on the device.

5. Select on the device display the System tab, and then click the Update button to select the

firmware for updating the device.

Lucid Series RF Signal Generator

Benchtop User Manual

to the USB flash memory.

Rev. 1.4

Table of Contents